Whirlpool WTW2000HW Owners Manual - Page 9

Level the Washer IMPORTANT: Level washer properly to reduce excess noise and vibration. For Permanent Installations: 11. Check levelness of washer B C A Move the washer to its final location. Place a level even with top edges of washer (B). Use side seam as a guide to check levelness of sides (A). Check levelness of front using lid, as shown (C). Rock washer back and forth to make sure all 4 feet make solid contact with floor. 13. P lug into a grounded 3 prong outlet Not Level LEVEL 12. Adjust leveling foot Not Level If the washer is not level, lay washer on its back to adjust the large black rubber leveling foot. If the washer is against a wall, move the washer out slightly before laying on its back. Use a crescent wrench to adjust the large black rubber leveling foot up or down as necessary. NOTE: The 3 smaller leveling feet are not adjustable. For Portable Installations: Check the levelness of the floor. If floor is not level, move washer to a level floor area. Complete Installation Checklist ❑❑ Check electrical requirements. Be sure you have correct electrical supply and recommended grounding method. ❑❑ Check that all parts are now installed. If there is an extra part, go back through steps to see what was skipped. ❑❑ Check that you have all of your tools. ❑❑ Check that shipping materials were completely removed from washer. ❑❑ Check that water faucets are on. ❑❑ Check for leaks around faucets and inlet hoses. ❑❑ Remove protective film from console and any tape remaining on washer. ❑❑ Check that washer is plugged into a grounded 3 prong outlet. ❑❑ Dispose of/recycle all packaging materials. ❑❑ Read "Washer Maintenance." ❑❑ To test and clean your washer, measure ½ of normal recommended amount of powdered or liquid detergent and pour it into washer basket or detergent dispenser (on some models). Close lid. Select any cycle. Start washer and allow to complete full cycle. 9