Whirlpool WTW4850BW Use & Care Guide - Page 4

CONTROL PANEL AND FEATURES 1 2 3 4 5 7 6 1 SOIL LEVEL Select the most suitable setting for your load. For heavily soiled and sturdy fabrics, select Heavy Soil Level for more wash time, if needed. For lightly soiled and delicate fabrics, select Ex Light Soil Level for less wash time, if needed. Lighter soil level setting will help reduce tangling and wrinkling. 2 WASH TEMP Wash Temp senses and maintains uniform water temperatures by regulating incoming hot and cold water. Select a wash temperature based on the type of fabric and soils being washed. For best results and following the garment label instructions, use the warmest wash water safe for your fabric. • On some models and cycles, warm and hot water may be cooler than your previous washer. • E ven in a cold and cool water wash, some warm water may be added to the washer to maintain a minimum temperature. 3 WASH CYCLE KNOB Use the Wash Cycle knob to select available cycles on your washer. See "Cycle Guide" for detailed descriptions of cycles. 4 RINSE OPTIONS The following options may be added to most cycles. See "Cycle Guide" for additional details. 1 RINSE This option is used to limit a cycle to one rinse. 2 RINSES This option can be used to automatically add a second rinse to most cycles. 1 RINSE with SOFTENER This option must be selected if using fabric softener during a cycle. It ensures that fabric softener is added at the correct time in the rinse for even distribution. 2 RINSES with SOFTENER This option turns on both the Softener and the 2 Rinses option. 5 PRESOAK Use this option to add an extra soak period to any cycle when washing heavily soiled garments. You can adjust the length of the soak period by changing the Soil Level. 6 START/PAUSE BUTTON Press to start the selected cycle; press again to pause the cycle and unlock the lid. NOTE: If the washer is spinning, it may take several minutes to unlock the lid. Press and hold 3 seconds to cancel a cycle. 7 CYCLE STATUS LIGHTS INDICATOR The Cycle Status Lights show the progress of a cycle. At each stage of the process, you may notice sounds or pauses that are different from traditional washers. SENSING When the START/Pause/Unlock button is pressed, the washer will first perform a self-test on the lid lock mechanism. You will hear a click, the basket will make a slight turn, and the lid will unlock briefly before locking again, this process may take 20 seconds to complete. Once the lid has locked the second time, the washer will use short, slow spins to estimate the load size. These sensing spins may take 2 to 3 minutes before water is added to the load and you may hear the hum of these spins. If the sensing light is on, then washer is working properly. You will hear the motor turn the basket in short pulses to thoroughly wet the load. The washer will then move the load briefly, pause to allow water to soak in to the load, and resume adding water. This process may repeat until the correct amount of water has been added for the load. NOTE: Avoid opening lid during sensing phase. The sensing process will start over when the washer is restarted. The sensing light may also come on during the Soak and Wash portions of the cycle. This is normal. To restart the washer after the lid has been opened press start. 4