Whirlpool WVI75UC6DS Use & Care Guide - Page 13

RANGE HOOD CARE Cleaning IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace grease filters before operating hood. Exterior Surfaces: To avoid damage to the exterior surface, do not use steel wool or soap-filled scouring pads. Always wipe dry to avoid water marks. Cleaning Method: ■ Liquid detergent soap and water, or all-purpose cleanser Non-Vented (recirculating) Installation Filters The charcoal filter is not washable. It should last up to 6 months with normal use. Replace with Charcoal Filter Kit Number W10412939. To replace charcoal filter: 1. Remove metal grease filter from range hood. See "Metal Grease Filters" in this section. 2. Bend spring clips away from metal grease filter. ■ Wipe with damp soft cloth or nonabrasive sponge, then rinse with clean water and wipe dry. Metal Grease Filters 1. Open the stainless steel panel. Grasp panel at the left corners and pull down to disengage the 2 catch pins from the spring catches. The panel is attached at the right and will rotate down. 3. Place charcoal filter into top side of metal filter. 4. Bend spring clips back into place to secure the charcoal filter to the metal filter. 2. Remove each filter by pulling the spring release handle and then pulling down the filter. A 5. Replace metal grease filter. See "Metal Grease Filters" in this section. Replacing a LED Lamp The LED lights are replaceable by a service technician only. See "Assistance and Service" section for service contact information. A. Spring release handle 3. Wash metal filter as needed in dishwasher or hot detergent solution. 4. Reinstall the filter by making sure the spring release handles are toward the front. Insert aluminum filter into upper track. 5. Push in spring release handle. 6. Push up on metal filter and release handle to latch into place. 13