Xerox 3300MFP Service Manual - Page 84
JAM 2
UPC - 095205744415
View all Xerox 3300MFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Error Messages and Codes JAM 2 Description 1. Paper is jammed in front of or inside the fuser. 2. Paper is stuck in the discharge roller and in the fuser just after passing through the Actuator-Feed. Fuser LSU CR OPC DR Toner Cartridge SR PTL Exit Sensor Pressure Roller Transfer Roller MP Sensor Feed Sensor Empty Sensor Feed Roller s3300mfp-069 Check and Cause Solution 1. If the paper is completely fed out of the 1. Check if the exit sensor actuator is printer, but Jam 2 occurs: Exit sensor is defective. defective. ■ Check if the actuator exit is deformed ■ After the paper is completely (Check if the lever part is deformed in discharged, actuator Exit should return to shape). the original position to shut off the photo- ■ Check whether burrs occur in the sensor. Sometimes it takes longer than it assembly part of the actuator exit or not should and does not return. and if the actuator is smoothly operated. ■ Check for foreign matter and if a wire is caught in the actuator exit's operation. 2. If the paper is rolled in the Fuser Roller: ■ This occurs when a Guide claw is broken away or deformed. ■ It occurs when the Guide claw spring is broken away or deformed. ■ It occurs when the Heat-Roller or Pressure-Roller is seriously contaminated with toner. 2. If the paper is stuck in the fuser: disassemble the fuser and remove the jammed paper, and clean the surface of the pressure roller with dry gauze. 3-4 Phaser 3300MFP Service Manual