Xerox 3635MFP Quick Use Guide - Page 37

English Troubleshooting A variety of situations can effect the quality of your output. For optimal performance, ensure the guidelines in the User Guide are followed. The documentation and the fault messages on the machine help you to locate and resolve a problem easily. Some problems can be resolved by switching off and switching on your device. Wait approximately 20 seconds before switching the machine ON. If after rebooting your machine the problem has not been resolved, have a look at some of the areas below to identify solutions. Problem The machine will not power on Documents will not feed through the Document Feeder The machine will not print from a workstation Cannot send an E-mail Paper jams Cannot fax a document Solution • Check to see that the machine is not in Low Power Mode as indicated by the green light on the Control Panel. Touch the User Interface screen to re-activate. • Check to see that the power cord is correctly installed. • Press the ON/OFF button to ON (I). • Ensure that all staples or paper clips have been removed from the originals. • Ensure the document feeder is not overloaded. Max. 50 documents. • Ensure that the edge guides are adjusted to touch the sides of the originals. • Make sure that an active network cable is connected to the workstation. • Check that the Network Setup is correct. Refer to Connecting to the Network on page 10. • Check if the machine is connected on the network as a printer. • Check that E-mail is enabled. Refer to E-mail Setup on page 14. • Load the paper in the paper trays with the seam side of the paper up. • Load the paper in the Bypass Tray with the seam side down. • If the paper curls excessively, flip the paper over in the applica- ble paper tray. • Use paper from a fresh package. • Ensure your machine is connected to a working telephone line and check for a dial tone. • Check that Fax is enabled. Refer to Fax Setup on page 16. quick use guide 33