Xerox 750DP DocuColor Server Administrator Guide - Page 42
Gateway, TCP/IP Setup with Token Ring, Gateway Setup, Gateway Address
![]() |
UPC - 042215455107
View all Xerox 750DP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
22-16 Setting up the DocuColor Exit TCP/IP Setup Ethernet Setup Token Ring Setup Gateway Setup TCP/IP Setup Network Setup Protocol Setup TCP/IP Setup Gateway If your TCP/IP network has a gateway, and users outside the gateway plan to print to the DocuColor using TCP/IP, choose Gateway Setup and enter the gateway address here. The gateway address applies to either a Token Ring or an Ethernet network. If TCP/IP is running on both an Ethernet and a Token Ring network, the gateway address you enter has to match the network number of either the Ethernet or the Token Ring network. Gateway Setup Gateway Address [127.0.0.1] Use this option to set the gateway address for printing with TCP/IP. By default, the loopback address, 127.0.0.1, is set. (The loopback address is a specially reserved address that allows for certain TCP/IP diagnostic tests to be run without being connected to a network.) Choose the next network type or choose Exit TCP/IP Setup and proceed to Service Setup. TCP/IP Setup with Token Ring Enable TCP/IP for Token Ring, and enter the IP address and subnet mask. Then, if your TCP/IP network has a gateway, and users outside the gateway plan to print to the DocuColor using TCP/IP, choose Gateway Setup and enter the gateway address (see page 2-16).
![](/manual_guide/products/xerox-750dp-docucolor-server-administrator-guide-70c735b/42.png)