Yamaha 16D NUAGE I/O 16D/16A/8A8D Operation Manual - Page 10

Setup Setup Overall Process This section explains how to set up the device for use with the DANTE ACCELERATOR. Before setting up, make sure that the following conditions are met. • The DANTE ACCELERATOR installed to the computer works properly. • The Dante Controller has already been installed. For details, refer to the DANTE ACCELERATOR manual. 1. Connect the device to a computer with a Ethernet cable.  "Connection between the Device and a Computer" (page 10) 2. Connect the power cable then turn the power on.  "Setting up the Power Supply" (page 11) 3. Configure the audio routing of the Dante network with the Dante Controller.  "Configuring the Audio Routing of the Dante Network" (page 11) 4. Install TOOLS for NUAGE.  "Installing TOOLS for NUAGE" (page 11) 5. Configure the Workgroup on NUAGE with the NUAGE Workgroup Manager.  "Configuring the Workgroup on NUAGE" (page 11) Connection between the Device and a Computer Connect the devices and computer by using a star connection or a daisy chain connection. Star Connection This section explains the connections when configuring a redundant network. 1. Connect the Ethernet cable as shown below. Ethernet port Computer DANTE ACCELERATOR PRIMARY SECONDARY Network switch ID#1 Network switch PRIMARY ID#2 CASCADE OUT SECONDARY CASCADE IN PRIMARY ID#3 CASCADE OUT SECONDARY CASCADE IN PRIMARY SECONDARY 2. Set the [UNIT ID rotary switch] on the rear panel to a unique ID. 3. Turn on (down) the [Dip switch] No.1 on the rear panel. NOTE Redundant network operation may not be available on the DANTE ACCELERATOR depending on its firmware version. Make sure that the firmware version currently on the DANTE ACCELERATOR supports a redundant network by checking the following website. IUUQXXXZBNBIBQSPBVEJPDPN 10 NUAGE I/O (16D )/ NUAGE I/O (16A) / NUAGE I/O (8A8D) Operation Manual