Yamaha 16D NUAGE I/O 16D/16A/8A8D Operation Manual - Page 11

Daisy Chain Connection 1. Connect the Ethernet cable as shown below. Computer Ethernet port DANTE ACCELERATOR PRIMARY Network switch ID#1 PRIMARY Setup Configuring the Audio Routing of the Dante Network 1. Launch Dante Controller. 2. In the "Routing" tab on the "Network View" window, set the audio routing by placing a check mark at the intersection of the desired devices. To use the link function with Nuendo, set up as follows. • Set the sample rate and pull-up/pull-down parameters on NUAGE I/O and DANTE ACCELERATOR to the same settings. • Join the inputs and outputs in the matrix. For example, set channels 1 through 16 on NUAGE I/ O to channels 1 through 16 on DANTE ACCELERATOR. CASCADE OUT ID#2 CASCADE IN SECONDARY PRIMARY CASCADE OUT ID#3 CASCADE IN SECONDARY PRIMARY 2. Set the [UNIT ID rotary switch] on the rear panel to a unique ID. 3. Turn off (up) the [Dip switch] No.1 on the rear panel. Setting up the Power Supply 1. Insert one plug of the power cable into the [AC IN] terminal on the device. 2. Insert the other plug of the power cable into a proper AC wall outlet. 3. Turn on (|) the power. WARNING Only use the included power cable (or an equivalent recommended by Yamaha). Using the wrong cable can result in damage to the device or overheating. CAUTION Remove the plug of the power cable from the outlet when the device is not be used for extended periods of time, or during electrical storms. NOTE For details on the Dante Controller, refer to the Dante Controller manual. Installing TOOLS for NUAGE To install TOOLS for NUAGE, double-click the installer file you have downloaded from the website. For details, refer to the TOOLS for NUAGE installation guide. Configuring the Workgroup on NUAGE To configure the Workgroup, open the NUAGE Workgroup Manager then register the devices and DAW software applications to the Workgroup. For details, refer to the NUAGE Workgroup Manager manual (PDF). To open the NUAGE Workgroup Manager manual, double-click the NUAGE Workgroup Manager icon on the task tray (Windows) or menu bar (Mac) for opening the window, then click the "Manual" icon. The setup is now completed. NUAGE I/O (16D )/ NUAGE I/O (16A) / NUAGE I/O (8A8D) Operation Manual 11