Yamaha 5490 Owner's Manual - Page 60
LOW FRQ TEST, 1F MAIN LEVEL main level
View all Yamaha 5490 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
SET MENU I 1F MAIN LEVEL (main level mode) Change this setting if you cannot match the output level of the center, rear (L/R) and rear center speakers with the main speakers because of the unusually high-efficiency performance of the main speakers. Choices: Normal, -10 dB Initial setting: Normal Normal Select this if you can match the output level of your effect speakers with that of your main speakers when using the test tone. 2 LOW FRQ TEST Use this feature to adjust the output level of the subwoofer so it matches that of the other speakers in your configuration. Change the setting with the remote control while sitting in the listening position. 1 Press j / i to set "TEST TONE" to ON, and adjust the volume with VOLUME +/- so you can hear the tone. 2 LOW FRQ TEST ≥ TEST TONE............ON OUTPUT...MAIN L/R FRQ 88Hz 1F MAIN LEVEL Normal -10dB -10 dB Select this if you cannot match the output level of your effect speakers with that of your main speakers when using the test tone. 1F MAIN LEVEL Normal -10dB Notes • Do not turn up the volume too high. • If no test tone is heard, turn down the volume, set this unit in the standby mode and make sure all the necessary connections are correct. 2 Press d to go to "OUTPUT" and press j / i to select the speaker you want to compare with the subwoofer. If SWFR is selected, the test tone above 90 Hz will not be output from the subwoofer. The test tone will not necessarily be output from the selected speakers. The output mode of the test tone depends on the settings of "1 SPEAKER SET" on the SET MENU. 2 LOW FRQ TEST TEST TONE.........OFF ≥ OUTPUT...MAIN L/R FRQ 88Hz 3 Press d to go to "FRQ" and press j / i to select the frequency you want to use. 2 LOW FRQ TEST TEST TONE.........OFF OUTPUT...MAIN L/R ≥ FRQ 88Hz 56