Yamaha 6240 Owners Manual - Page 21
Connecting the FM and AM antennas, Connecting the power cable, Turning this unit on and off
UPC - 027108933276
View all Yamaha 6240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
INTRODUCTION PREPARATION BASIC OPERATION Connections Connecting the FM and AM antennas An indoor FM antenna and an AM loop antenna are supplied with this unit. Connect these antennas properly to the respective jacks. Connecting the power cable After all connections are complete, plug the AC power cable of this unit into an AC wall outlet. Indoor FM antenna Outdoor AM antenna Connect a 5 to 10 m (16 to 33 ft) vinyl-covered wire, and extend it outdoors (use the AM loop antenna together with this antenna). AM loop antenna DOCK COMPONENT VIDEO PR PB Y VIDEO HDMI OUT ANTENNA UNBAL. (BD/DVD) HDMI 1 COMPONENT VIDEO PR HDMI 2 FM GND AM PB Y VIDEO MONITOR OUT HDMI 3 F Ground (GND terminal) The GND terminal is not for earth grounding. To reduce noises, connect a ground bar or a vinyl-covered wire with a copper plate at its tip, and place it in the moist ground. y • The supplied antennas are normally sensitive enough to obtain good reception. • Position the AM loop antenna away from this unit. • If you cannot get good reception, we recommend that you use an outdoor antenna. For more details, consult the nearest authorized Yamaha dealer or service center. • Always use the AM loop antenna even when the outdoor antenna is connected. Assembling the AM loop antenna To the AC wall outlet Power cable Turning this unit on and off 1 Press ASTANDBY/ON on the front panel (or fPOWER on the remote control) to turn on this unit. 2 Press ASTANDBY/ON (or fPOWER) again to turn off this unit (standby mode). y • The unit needs a few seconds until ready to play back. • You can also turn on this unit by pressing ISCENE (or kSCENE). • This unit consumes a small amount of electricity even in the standby mode. We recommend disconnecting the power cable from the AC wall outlet. Caution Do not unplug this unit while it is turned on. Doing so may damage this unit or cause the settings of this unit to be saved incorrectly. Connecting the AM loop antenna The wires of the AM loop antenna have no polarity. You can connect either wire to the AM terminal and the other to the GND terminal. Press and hold Insert Release ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 17 En