Yamaha 6240 Owners Manual - Page 49

INTRODUCTION PREPARATION BASIC OPERATION Advanced setup In the advanced setup, you can set basic operations of this unit, such as on and off of a bi-amp connection, or initialize user settings. Perform the following steps to change settings. 1 Set this unit to the standby mode. 2 Press ASTANDBY/ON while pressing and holding LSTRAIGHT on the front panel. The advanced setup menu appears on the front panel display. ADVANCED SETUP 3 Press KPROGRAM l / h repeatedly to select the parameter you want to change. The default setting are marked with "*." y • XXX in the following parameters indicate the set values. SP IMP. - XXX Choices: 6 MIN/8 MIN* Selects output impedance of this unit according to connected speakers. REMOTE ID-XXX Choices: ID1*/ID2 Sets a remote control ID. When using multiple Yamaha AV receivers, you can operate them with a single remote control by setting the receiver IDs to the same setting. INIT-XXXXXXXXX Choices: DSP PARAM/ALL/CANCEL Initializes various settings stored in this unit. You can select an initialization method from the following. Setting a remote control ID Two IDs are provided for the remote control of this unit. If another Yamaha amplifier is in the same room, setting a different remote control ID to this unit prevents unwanted operation of the other amplifier. ID1 is set for both remote control and amplifier by default. When you change the remote control ID, display "Advance Setup" (see the previous section) and change the ID for the amplifier too. 1 Press cCODE SET on the remote control using a pointed object such as the tip of a ballpoint pen. bTRANSMIT blinks twice. 2 Press lSETUP on the remote control. 3 Enter the desired remote control ID code. To switch to ID1: Enter "5019" using sNumeric keys. To switch to ID2: Enter "5020" using sNumeric keys. Once the remote control code is registered, bTRANSMIT blinks twice. If it fails, bTRANSMIT blinks six times. Repeat from step 1. y • Initializing the remote control code (see page 44) returns it to ID1. DSP PARAM: All parameters of sound field programs ALL: Reset this unit to initial factory settings CANCEL: Cancellation of initialization 4 Press LSTRAIGHT a few times to select the value you want to change. The value selected here becomes effective when this unit is turned on the next time. You can change multiple settings by repeating steps 3 and 4. 5 Press ASTANDBY/ON, turns off this system, and press ASTANDBY/ON again. The value set in step 3 becomes effective, and this unit turns on. When you select initialization in step 3, the initialization is performed. ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 45 En