Yamaha 800 Owner's Manual - Page 7
Connecting Your Amplifier/receiver, Painting The Speaker Grille, Specifications
View all Yamaha 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
English CONNECTING YOUR AMPLIFIER/RECEIVER Before making connections, make sure that the amplifier/receiver is switched off. • When connecting, also refer to the owner's manual of the connected equipment. Connections • Connect the push input terminals at the rear of the speakers to the speaker output terminals of the amplifier/receiver with the speaker cables (not included). • Connect each speaker making sure not to reverse the polarity "+" (red), "-" (black). If the speaker is connected with reversed polarity, the sound will be unnatural and lack bass. How to connect 1 Remove approximately 10 mm (3/8") of insulation from the end of each speaker cable using wire strippers, and then twist the exposed wires of the cable together to prevent short circuits. 2 Press and hold down the speaker terminal. 3 Insert the bare wire into the hole in the side of each terminal. 1 10mm 2 (3/8") After connecting • Lower the power amplifier/receiver volume control before changing input sources. Never change input sources (for example, FM to CD) at high listening levels. Always turn the receiver/amplifier unit off when installing or removing any cables. • Anytime you note distortion, reduce the volume control on your power amplifier/receiver to a lower setting. Never allow your power amplifier to be driven into "clipping". PAINTING THE SPEAKER GRILLE The speaker grilles can be painted to match your room décor. Use high quality spray paint and select a well ventilated area before proceeding. 1 Carefully remove the grille from the speaker if attached. 2 Remove the scrim cloth that is attached to the back of the grille. (The adhesive that holds the cloth in place is reusable.) 3 Apply the paint to the grille. • Make sure that the grille holes remain free of paint. • Clogging the holes with paint may diminish the sound quality. 4 When the paint has fully dried, re-attach the scrim cloth to the back of the grille. 5 Re-install the grille on the speaker. 3 No Good Good -+ -+ NS-IC600/ NS-IC800 (R) Receiver or amplifier R +- L A -+ B NS-IC600/ NS-IC800 (L) Speaker output terminals 4 Release the terminal. • Test the firmness of the connection by pulling lightly on the cable at the terminal. CAUTION • Do not let the bare speaker wires touch each other as this could damage the speaker or amplifier/receiver, or both. SPECIFICATIONS Type Tweeter Driver Woofer Frequency response Impedance Nominal input Maximum input Sensitivity Crossover frequency Dimensions (with grille) Weight (with grille) NS-IC600 NS-IC800 2-way Open back type 2.5 cm (1") Soft dome type 16 cm (6.5") Cone type 20 cm (8") Cone type 65 Hz to 28 kHz (-10dB) 50 Hz to 28 kHz (-10 dB) 8 ohms 40 W 110 W 90 dB / 2.83 V, 1 m 50 W 140 W 3.2 kHz 3.5 kHz φ242 × 119D mm (φ9-1/2" × 4-5/8"D) φ283 × 120D mm (φ11-1/8" × 4-3/4"D) 1.5 kg (3.3 lbs) 1.9 kg (4.2 lbs) * Specifications subject to change without notice due to product improvements. * Speaker cables are not included with this model. 6 En