Yamaha AX-592 Owner's Manual - Page 13

English AX-892 E 1 2 3 NATURAL SOUND STEREO AMPLIFIER AX-892 CD DIRECT AMP POWER 10 1 2 2 3 3 4 - 5 4 5 + BASS 10 1 2 2 3 3 4 - 5 4 5 + TREBLE ON OFF SUBSONIC FILTER 10 1 2 2 3 3 4 L 5 4 5 R BALANCE 1 FLAT 2 3 -30db 10 9 4 8 5 7 6 LOUDNESS TAPE 1 CD TUNER TAPE 2 (MD) AUX PHONO REC OUT INPUT CD TAPE 1 TUNER TAPE 2 (MD) PHONO AUX PHONES SPEAKERS A B ON OFF PURE DIRECT VOLUME 16 20 12 28 8 40 4 60 ∞ -db 2 0 MUTING ON OFF D C B 45 678 9 0 A 1 Remote control sensor Receives signals from the remote control. 2 POWER switch Press this switch to turn the power on and off. When the power is on, the indicator will be illuminated. *Standby mode While the power is on, pressing the POWER key on the remote control switches the unit to the standby mode. (In this mode, the power indicator on the unit is halfilluminated.) 3 PHONES jack When you listen with headphones, connect the headphones to the PHONES jack and set both SPEAKERS A and B switches to OFF. PHONES 4 SPEAKERS switches For the desired speaker system(s), set the switch(es) to ON. When using only one speaker system, set the other switch to OFF. 5 BASS control Used to increase or decrease the low-frequency response. Selecting "0" produces a flat response. 6 TREBLE control Used to increase or decrease the high-frequency response. Selecting "0" produces a flat response. 7 SUBSONIC FILTER switch AX-592 and AX-892 only Used to eliminate undesirable ultra-low-frequency signals caused by turntable rumble or warped records without losing sound quality. 8 BALANCE control Adjusts the balance of the output volume to the left and right speakers to compensate for channel imbalance caused by speaker location or listening room conditions. 9 Continuously variable LOUDNESS control Used to boost high and low-frequency ranges at low volume. (Refer to page 18.) 0 REC OUT selector This switch can be used to select a source and send its signal directly to the REC OUT terminals on the rear panel, independently of the setting of the INPUT selector. This function allows you to record the selected source while listening to another source. A INPUT selector Selects an input source to listen to. B MUTING switch AX-892 only Press this switch to temporarily reduce the volume. Press again to cancel the MUTING function. C VOLUME control and indicator Used to raise or lower the volume level. AX-592 and AX-892 only D PURE DIRECT switch Press this switch (the indicator lights up) to listen to a source in the purest possible sound. (Refer to page 19.) E CD DIRECT AMP switch Press this switch (the indicator lights up) to listen in the purest possible sound from your CD. (Refer to page 19.) 13