Yamaha CC-90 Owner's Manual - Page 14

PREPARATION FOR USE For connecting with NX-S90 RL Speaker connection Connect each speaker wire to the SPEAKERS terminals. Cautions • Do not let the bare speaker wires touch each other as this could damage the amplifier and/or speakers. • When connecting the speakers to this system, be sure to connect the speaker wires properly. Do not mistake the right channel for the left channel and the plus (+) terminal for the minus (-) terminal. • Set the SPEAKERS SELECTOR switch on the rear panel of MX-S90 to the proper position before connections. If you use YAMAHA Active Servo Processing Speaker System NX-S90, set this switch to "NX-S90". If you use a speaker system other than NX-S90, set this switch to "CONVENTIONAL". (Black wire with white line → plus (+) terminal, black wire → minus (-) terminal) CTX-S90 (U.S.A. model) MX-S90 Connecting the AC supply leads These connections must be done after all other connections have been completed. • First, plug the AC supply lead of MX-S90 into the AC OUTLET on the rear of CTX-S90. • Next, plug the AC supply lead of CTX-S90 into a wall AC outlet. * Unplug the AC supply lead of CTX-S90 from the AC outlet if the system is not to be used for a long period of time. To an AC outlet AC OUTLET (SWITCHED) on the rear panel of CTX-S90 Use this to connect the AC supply lead from another component to CTX-S90. The power to this outlet is controlled by the POWER switch of CTX-S90 or the provided remote control transmitter. This outlet will supply power to the connected component whenever CTX-S90 is turned on. The maximum power (power consumption of component) that can be connected to the AC OUTLET (SWITCHED) is 420 watts. It is the best way to connect the AC supply lead of MX-S90 to this outlet. By doing so, the power of the whole system can be turned on/off by the POWER switch of CTX-S90 or the provided remote control transmitter. After the connection, keep the POWER switch of MX-S90 in the ON position. 12