Yamaha CD S700 Owner's Manual - Page 23
Troubleshooting, English, Additional, Information - problems
UPC - 027108932057
View all Yamaha CD S700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
ADDITIONAL INFORMATION TROUBLESHOOTING If the unit fails to operate normally, check the following points to determine whether the problem can be corrected by the simple measures suggested. If it cannot be corrected, or if the problem is not listed in the Problems column, disconnect the power cable and contact your authorized Yamaha dealer or service center for help. Problems Possible Causes Solutions Refer to page This unit fails to turn The power cable is not connected to the AC IN Connect the power cable firmly. on. inlet on the rear panel or not plugged in the wall 8 outlet. The disc tray does A foreign object is obstructing the tray. not close completely. Carefully check the disc tray and remove the foreign object. - Disc playback does not start. The disc is damaged. There is moisture on the laser pickup. Check the disc carefully; replace it if necessary. - Wait 20 to 30 minutes after switching on the unit ON before trying to play back a disc. - The disc is loaded upside down. Reload the disc with the label side up. 9 The disc is dirty. Clean the disc. 18 The format of the MP3 or WMA file is not compatible with this unit. Replace the disc with a correctly recorded disc playable with this unit. 17 The CD-RW (ReWritable) disc is not recorded correctly. Replace the disc with a correctly recorded disc playable with this unit. 17 The disc is a non-standard disc not playable with Replace the disc with a correctly recorded disc this unit. playable with this unit. 17 This unit is in USB mode. Switch to disc mode by pressing CD/USB. 5, 9 USB playback does Improper USB device connections. Connect the USB device again. 8 not start. The format of the MP3 or WMA file is not compatible with this unit. Replace the file with a correctly recorded file playable with this unit. 17 This unit is in disc mode. Switch to USB mode by pressing CD/USB. 5, 9 Playback is delayed, or begins at the wrong place. The disc may be scratched or damaged. Check the disc carefully; replace it if necessary. 18 No sound. Improper output cable connections. Connect the cables properly. If the problem persists, the cables may be defective. 7 Improper amplifier operation. Set the amplifier controls to the correct input selection. - Sound of a component connected to the DIGITAL OUT jacks is not played. PURE DIRECT is turned on. Turn PURE DIRECT off. Or make an analog connection. 10 Sound "skips". This unit is being subjected to vibrations or impacts. Relocate this unit. - The disc is dirty. Clean the disc. 18 Sound "hums". Improper cable connections. Securely connect the audio cables. If the problem persists, the cables may be defective. 7 Noise from a nearby The tuner is too close to this unit. tuner. Move the tuner and this unit farther apart. - Noise from inside of The disc may be warped. the disc tray. Replace the disc. - English 19 En