Yamaha CDC-765 Owner's Manual - Page 22

Display information during programming 1 2 3 4 5 6 7 8 9 10 PROG TOTAL REMAIN Œ  1 2 3 4 5 6 7 8 9 10  Ž PROG TOTAL REMAIN Œ Shows the side of the tape and the program number for the track to be programmed next.  Shows the selected disc and track number. Ž Shows the total remaining time on the side of the tape.  Programmed track numbers light up and programmable track numbers among the unprogrammed ones flash on and off. * If "A-01" does not appear on the display after the PROG button is pressed, press the TIME display mode-select button. * If, during programming, the TIME display mode-select button is pressed, the program number display can be changed to display the total remaining time on the side of the tape. To return to the previous display, press the TIME display modeselect button once again. s Random sequential tape programming The unit will automatically program tracks on a disc in random sequential order for recording to tape. 4 SYNCHRO 1 4 DIMMER TIME OPEN/ CLOSE TAPE CLEAR PROG 2 3 INDEX 5 6 +I0 7 8 9 0 DISC SCAN MODE REPEAT RANDOM DISC SKIP SEARCH - OUTPUT LEVEL + SKIP STOP PAUSE PLAY 2 3, 4 1 Follow step 1 - 5 on page 20. 2 RANDOM * The unit will automatically program tracks for side A and side B separately considering the tape's total time. 3 Begin recording on the tape deck and press the PLAY button on this unit at the same time. 4 The unit will pause at the end of side A of the tape. Turn the tape over to side B. Resume recording and, at the same time, press the PLAY or PAUSE button on this unit. 22 Notes q Because the programmed data changes every time the RANDOM button is pressed, the amount of time remaining at the end of the tape also changes accordingly. q If the tape's length is not enough, all tracks cannot be programmed. In this case, exchange the tape for a longer one. q In step 2, you can check the program data for side A and side B. Œ  1357 PROG TOTAL Ž Œ Shows the number of programmed tracks for each side in turn just after the automatic programming is finished, and then it is replaced by the number of the first programmed track for side A.  Shows the total time of programmed tracks for each side. Ž Shows the programmed track numbers for each side. q CD synchronized recording function can be used if your tape deck is compatible with it. In this case, in step 3 and 4, press the SYNCHRO button and then press the PLAY button on this unit's remote control transmitter. Recording automatically begins. (For details, refer to page 19.)