Yamaha CDC-902 Owner's Manual - Page 5

English CONNECTIONS q Before making any connections, switch OFF the power to the unit and the amplifier or other component. q Connections should be made to the correct input terminals of the amplifier or other component. q If the placement of this unit causes noise to other equipment, such as a tuner, separate them from each other. LINE OUT CDC-502 LINE OUT DIGITAL AUDIO OUT OPTICAL CDC-902 To AC outlet – Connection cord (included) – Connection cord (included) To AC outlet — Optical fiber cable (not included) CD OPTICAL DIGITAL IN Amplifier Choose one of the ways listed below to connect this unit to your amplifier. When the LINE unit are used ( O–U)T (analog) terminals of this q Be sure that the left ("L") and right ("R") LINE OUT terminals are connected to the corresponding (left and right) terminals of the amplifier or other component. q Connect the "LINE OUT" terminals to the "CD" (or "AUX") terminals of the amplifier. If the amplifier does not have such terminals, use the "TAPE PB" terminals. For additional details concerning these connections, refer to the operation instructions for the amplifier being used. q CDC-902 only Adjust the level of signals output into an amplifier, etc. by using the OUTPUT LEVEL button. CDC-902 only WterhmenintahleoDf tIhGiIsTAunLitAiUsDuIsOedOU(T—(O) PTICAL) q Before using this terminal, remove the terminal's cover by pulling it. q Make the connection from this terminal to the optical input terminal of an amplifier by using a commercially available optical fiber cable. * Use an optical fiber cable that conforms to EIAJ standards. Other cables might not function correctly. q Be sure to attach the terminal's cover when this terminal is not being used, in order to protect the terminal from dust. q Set the level of signals output into an amplifier to max. by using the OUTPUT LEVEL button. q This terminal can also be connected to the optical input terminal of a digital audio tape deck (DAT) etc. to record CD onto tape directly. 5