Yamaha DSP-AX3200 Owner's Manual - Page 15
Impedance Selector Switch, English, Introduction, Basic Opera, Advanced, Operation, Additional
View all Yamaha DSP-AX3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
INTRODUCTION PREPARATION I IMPEDANCE SELECTOR switch SPEAKER SETUP WARNING Do not change the IMPEDANCE SELECTOR switch setting while the power of this unit is on, otherwise this unit may be damaged. If this unit fails to turn on when STANDBY/ON (or SYSTEM POWER) is pressed, the IMPEDANCE SELECTOR switch may not be fully slid to either position. If so, slide the switch to either position fully when this unit is in the standby mode. Select the left and right position according to the impedance of the speakers in your system. Be sure to move this switch only when this unit is in the standby mode. IMPEDANCE SELECTOR switch Switch Speaker position Impedance level IMPEDANCE SELECTOR SET BEFORE POWER ON REAR : 6ΩMIN. /SPEAKER REAR CENTER : 6ΩMIN. /SPEAKER CENTER : 4ΩMIN. /SPEAKER MAIN A OR B : 4ΩMIN. /SPEAKER A+B : 8ΩMIN. /SPEAKER REAR : 8ΩMIN. /SPEAKER REAR CENTER : 8ΩMIN. /SPEAKER CENTER : 8ΩMIN. /SPEAKER MAIN A OR B : 8ΩMIN. /SPEAKER A+B : 16ΩMIN. /SPEAKER Upper Main If you use one set of main speakers, the impedance of each speaker must be 4 Ω or higher. If you use two sets of main speakers, the impedance of each speaker must be 8 Ω or higher. Center The impedance must be 4 Ω or higher. Rear The impedance must be 6 Ω or higher. Center Rear The impedance of each speaker must be 6 Ω or higher. AC OUTLETS SWITCHED IMPEDANCE SELECTOR SET BEFORE POWER ON REAR : 6ΩMIN. /SPEAKER REAR CENTER : 6ΩMIN. /SPEAKER CENTER : 4ΩMIN. /SPEAKER MAIN A OR B : 4ΩMIN. /SPEAKER A+B : 8ΩMIN. /SPEAKER REAR : 8ΩMIN. /SPEAKER REAR CENTER : 8ΩMIN. /SPEAKER CENTER : 8ΩMIN. /SPEAKER MAIN A OR B : 8ΩMIN. /SPEAKER A+B : 16ΩMIN. /SPEAKER 100W MAX. TOTAL Lower Main If you use one set of main speakers, the impedance of each speaker must be 8 Ω or higher. If you use two sets of main speakers, the impedance of each speaker must be 16 Ω or higher. Center The impedance must be 8 Ω or higher. Rear The impedance must be 8 Ω or higher. Center Rear The impedance of each speaker must be 8 Ω or higher. (Europe model) BASIC OPERATION ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 13