Yamaha DSP-AX3200 Owner's Manual - Page 40
Setting the Manufacturer Code
View all Yamaha DSP-AX3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
REMOTE CONTROL FEATURES Setting the Manufacturer Code You can control other components by setting a manufacturer code. A code can be set up in each component control area. The following table shows factory-set component (Library: component category) and the manufacturer code for each area. If you are to make a setting for different component from the factory setting, change the library as described in step 3 on right. 3 Press k / n to select the name of your component's manufacturer. You will find the names of most worldwide audiovideo manufacturers in alphabetical order in the display window. ENTER Input area A B PHONO TUNER CD V-AUX CBL/SAT MD/TAPE CD-R D-TV/LD VCR 1 VCR 2/DVR DVD Component category (Library) LD SATELLITE TUNER TV TUNER CD VCR CABLE MD CD-R TV VCR VCR DVD Manufacturer YAMAHA - - YAMAHA YAMAHA - - YAMAHA YAMAHA - - - YAMAHA 1 Press an input selector button, Å or ı to select the source component you want to set up. A B PHONO V-AUX TUNER MD/TAPE CD-R CD D-TV/LD CBL/SAT VCR 1 VCR2/DVR DVD If you want to change a library (component category), press l / h. You can set a different component from the input selector name. Library choices: DVD, LD, CD, CD-R, MD, TAPE, TUNER, AMP, TV, CABLE, DBS, SAT, VCR Note If the manufacturer of your component has more than one codes, try each of them until you find the correct one as checking if it works following step 4. 4 Press one of the buttons shaded below to check if it works for the component being set. If it does, the manufacturer code setting has been correctly made. TITLE 6CH INPUT SOURCE DISPLAY MENU SELECT SEARCH ENTER SOUND - CHAPTER + POWER REC STOP PAUSE PLAY 2 Press and hold LEARN for about 3 seconds by using a ballpoint pen or similar object. "SETUP" and the selected component name appear alternately in the display window. LEARN y • If you continuously want to set up another code for another component, press ENTER and repeat steps 1, 3 and 4. 5 Press LEARN again to exit from the setup mode. LEARN Notes • Press LEARN for at least 3 seconds, otherwise the learning process is started. • If you do not press any button within 30 seconds during step 3, the setup process is canceled. If this happens, start over from step 2. Notes • If you have already programmed a remote control function for a button, the function by learning or macro programming takes priority over the setup manufacturer code's function. • "ERROR" appears in the display window under the following circumstances: - when pressing a button other than the cursor and ENTER; - when pressing more than one button at once; or - when MACRO ON/OFF, 10KEY/DSP or PARAMETER/SET MENU is switched to another position. 38