Yamaha DSP-E492 Owner's Manual - Page 10

EXAMPLES OF BASIC CONNECTIONS Never plug in this unit and other components until all connections are completed. Note When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left) to L, R (right) to R, "+" to "+" and "-" to "-". Also, refer to the owner's manual for each component to be connected to this unit. * If you have YAMAHA components numbered as 1, 2, 3, etc. on the rear panel, connections can be made easily by making sure to connect the output (or input) terminals of each component to the same-numbered terminals of this unit. 1 When this unit is used as a main controller Monitor TV LD player etc. Amplifier (for driving main speakers) Main speakers Left Right VIDEO IN AUDIO OUT VIDEO OUT MAIN IN See page 11. 6CH DISCRETE INPUT VIDEO SIGNAL MAIN CENTER REAR MAIN CENTER REAR INPUT from AMP/RECEIVER PREOUT MAIN SUB WOOFER (SURROUND) SUB WOOFER (SURROUND) MONITOR OUT DVD/LD TV/DBS IN OUT VCR AUDIO SIGNAL 1 CD (LINE 1) 2 3 TAPE PB REC OUT 4 TUNER (LINE 2) TAPE ( MD ) DVD/LD INPUT TV/DBS IN OUT VCR OUTPUT (Europe model) MAINS To AC outlet OUTPUT l0 dB 0 dB MAIN LEVEL I00W MAX. SWITCHED AC OUTLET OUTPUT OUTPUT LINE OUT LINE IN l VIDEO OUT AUDIO OUT AUDIO OUT AUDIO IN VIDEO IN VIDEO OUT CD player Tuner Tape deck, MD recorder, etc. Notes q If you select this connecting way, the PROCESSOR SELECTOR switch on the front panel of this unit must be set to the "INTERNAL" position. q For speaker connections, see page 12 - 13. TV/Satellite tuner Video cassette recorder 10