Yamaha DTX-MULTI Owner's Manual - Page 83
System Settings, Master Volume Startup Kit Effect Bypass
View all Yamaha DTX-MULTI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
UTILITY Setting Area (UTIL) Reference KIT VOICE MIDI UTIL1 GENERAL System Settings UTIL1 GENERAL In the GENERAL section, you can set parameters affecting the entire system. With the GENERAL page (UTIL1) displayed, press the [ENTER] button to access its eight parameter-setting pages (UTIL1-1 to UTIL1-8). You can use the [B]/[C] buttons to navigate between these pages. UTIL1-1 Master Volume page UTIL1-1 MasterVolume=127 1 1 Master volume Use this parameter to set the master volume of the instrument's internal tone generator. If a small value is set here, the VOLUME dial on the front panel will have very little effect in increasing the output volume. Settings 0 to 127 UTIL1-2 Master Tune page UTIL1-4 Startup Pattern page UTIL1-4 StartupPtn=©P001 1 1 Startup pattern (StartupPtn) Use this parameter to select the pattern that will be automatically set when the DTX-MULTI 12 is turned on. Patterns are identified using a category (eP for Preset, eU for User) and a number, and you can move the cursor using the [B]/[C] buttons to set these individually. Settings eP001 to eP128 or eU001 to eU050 UTIL1-5 Startup Trigger page UTIL1-5 ≥StartupTrg=P01 1 1 Startup trigger (StartupTrg) Use this parameter to select the trigger setup that will be automatically selected when the DTX-MULTI 12 is turned on. Trigger setups are identified using a category (P for Preset, U for User) and a number, and you can move the cursor using the [B]/[C] buttons to set these individually. Settings P01 to P05 or U01 to U10 UTIL1-2≥≥M.Tune= +≥≥0.0(440.0Hz) 1 1 Master tune (M.Tune) Use this parameter to tune (i.e., adjust the basic pitch of) the internal tone generator. The value in parentheses shows the corresponding tuning (of A above middle C) in Hertz. Settings -102.4 to +0.0 to +102.3 NOTE • The term "cent" refers to one hundredth of a semitone (i.e., 100 cents = 1 semitone). UTIL1-3 Startup Kit page UTIL1-3 StartupKit=P001 1 1 StartupKit Use this parameter to specify the kit to be automatically selected when the DTX-MULTI 12 is turned on. Kits are identified using a category (P for Preset, U for User) and a number, and you can move the cursor using the [B]/[C] buttons to set these individually. Settings P001 to P050 or U001 to U200 UTIL1-6 Effect Bypass page UTIL1-6≥≥FXByps= ≥≥var/cho/rev 12 3 1 Variation effect (var) B Chorus effect (cho) C Reverb effect (rev) Use these parameters to specify which effects will be bypassed when Effect Bypass is activated from the front panel (using the [SHIFT] and [KIT] buttons). When "---" is selected for an effect type, it will not be bypassed. Settings ---/var, ---/cho, or ---/rev Owner's Manual 83 WAVE PATTERN UTILITY TRIGGER