Yamaha DTX-MULTI Owner's Manual - Page 89
Hi-hat Setup, Foot Switch Input Pad 10-12 Switch Close Position
View all Yamaha DTX-MULTI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Reference KIT VOICE UTILITY Setting Area (UTIL) UTIL4-2 Foot Switch Input page UTIL5-1 Close Position page UTIL4-2 PAD> FootSwInSel=ftSw 1 1 Foot switch input selection (FootSwInsel) Use this parameter to specify whether a foot switch ("ftSw"), a hi-hat controller ("HH65"), or a foot controller ("FC7") is connected via the FOOT SW jack. Settings ftSw, HH65, or FC7 NOTE • The velocities sent when a hi-hat controller or a foot controller is connected will depend on the setting made on the Trigger Velocity page (MIDI1-7). • The velocities sent when a foot switch is connected also depend on the setting made on the Trigger Velocity page (MIDI1-7); however, if "variable" is selected on that page, velocities will be sent with a fixed value of 100. UTIL4-3 Pad 10-12 Switch page UTIL4-3 PAD> Pad10-12=enable 1 1 Pad10-12 Use this parameter to turn rim pads 10 to 12 on ("enable") or off ("disable"). This function can prove useful in preventing voices assigned to these rim pads from being played when they are accidentally struck instead of pads 7 to 9. • enable The rim pads will operate in the normal way. • disable Functions assigned to these rim pads will be disabled. When they are struck, the DTX-MULTI 12 behaves in the same way as if the corresponding main pads (7 to 9) had been struck. Settings enable or disable UTIL5 HI-HAT Hi-hat Setup UTIL5 HI-HAT In the HI-HAT section, you can set parameters related to hi-hats. With the HI-HAT page (UTIL5) displayed, press the [ENTER] button to access its three parameter-setting pages (UTIL5-1 to UTIL5-3). You can use the [B]/[C] buttons to navigate between these pages. UTIL5-1≥ ≥ClosePosi=+10 1 1 Close position (ClosePosi) Use this parameter to adjust the position at which the hi-hat switches from open to closed when a hi-hat controller is depressed. The lower the value, the smaller the virtual opening between the top and bottom hi-hats. Settings -32 to +0 to +32 UTIL5-2 Splash Sensitivity page UTIL5-2≥ ≥SplashSens=127 1 1 Splash sensitivity (SplashSens) Use this parameter to set the degree of sensitivity for detecting hi-hat foot splashes. The higher the value, the easier it will be to produce foot-splash sounds with the hi-hat controller. High values may, however, result in splash sounds being unintentionally produced when, for example, you depress the hihat controller lightly to keep time. It is a good idea to set this parameter to "off" if you do not want to play foot splashes. Settings off or 1 to 127 UTIL5-3 Send Hi-hat Controller page UTIL5-3≥ ≥≥≥SendHH=on 1 1 Send hi-hat controller (SendHH) Use this parameter to enable ("on") or disable ("off") the sending of MIDI messages corresponding to continuous motion of the hi-hat controller between the open and closed positions. Settings off or on NOTE • If "hi-hat" is selected on the Hi-Hat Function page (KIT7-3), MIDI messages will be sent only when this parameter is set to "on". • If "MIDI" is selected on the Hi-Hat Function page (KIT7-3), MIDI messages will always be sent, regardless of whether this parameter is set to "on" or "off". MIDI WAVE PATTERN UTILITY TRIGGER Owner's Manual 89