Yamaha DTX432K DTX402K/DTX432K/DTX452K Owners Manual - Page 22

Setup Assembly Guide Step 14 Connecting the pads to the drum module TOM2 TOM1 CR Trigger input jacks on the drum module RIDE TOM3 HH SNR SNR TOM1 TOM2 TOM3 RIDE CR HH HHC KICK DTX402K KICK KICK HHC HHC CR TOM1 TOM2 HH Nine-channel snake cable SNR RIDE TOM3 KICK HHC 1. Insert the mini plugs* at one end of the nine-channel snake cable into the correct trigger input jacks (SNARE to KICK/ PAD) on the drum module. (*: The smaller set of plugs.) NOTE The sticker on each of the snake cable's plugs indicates the name of the corresponding pad. 2. Insert the nine-channel snake cable's standard plugs* into the jacks in the corresponding pads. (*: The larger set of plugs.) NOTE For the kick pad KP65 in the DTX432K and DTX452K, use the OUT>DTX jack. No sound will be played when the PAD>IN jack is used. 3. Wrap the cables for the snare pads, the tom pads, and the cymbal/hi-hat pads around the cord clip to prevent them from being pulled out. NOTICE Excessive bending can damage the cables. Ensure, therefore, that they are not bent at an extreme angle when wrapped around the cord clip. 4. Using the cable bands, secure the cables to the kit rack at the positions in the figure above. Congratulations-You have finished assembling your electronic drum kit! Setup for Left-handed Drummers Fully assembled drum kit (DTX452K shown) Assemble the drum kit referring to the illustration. Two of the joints should be placed differently from this setup for righthanded drummers. Right-handed Left-handed 20 DTX402K DTX432K DTX452K Owner's Manual