Yamaha DTX432K DTX402K/DTX432K/DTX452K Owners Manual - Page 46

Advanced Techniques Setting Parameters using Menu Mode 2-3. Pad Tuning Steps: Hold down the Mode switch  [2]  [3]  Setting Setting You can adjust the panning of the current kit's pads. 1. Hold down the Mode switch to activate Menu Mode. 2. Press number button [2] to select the Kit Settings parameter group. 3. Press number button [3] to select the Pad Panning parameter. 4. Strike a pad to select it. 5. Enter a new tuning setting using the TEMPO[+]/[-] buttons in 25 cent steps. The "cent" is a unit of measure for musical intervals. 100 cents make up a semitone. A value of 64 corresponds to normal pitch (0 cents). Setting 16 (-1200 cents) to 64 (0 cent) to 112 (+1200 cents) 2-4. Double Bass Drum Steps: Hold down the Mode switch  [2]  [4]  Setting Setting You can easily configure the drum module to produce a kick drum sound when you operate the pedal connected to the [HI-HAT CONTROL] trigger input jack. This convenient function provides support for double bass drumming techniques. 1. Hold down the Mode switch to activate Menu Mode. 2. Press number button [2] to select the Kit Settings parameter group. 3. Press number button [4] to select the Double Bass Drum parameter. 4. Set the parameter using number button [1] or [2]. The available settings are as follows. Number button [1] Off [2] On Setting NOTE • While the Double Bass Drum function is enabled, you will be unable to use the hi-hat controller plugged into the [HI-HAT CONTROL] trigger input jack to simulate opening and closing of the hi-hat. • If using an HH40 Hi-hat Controller, you can adjust the kick velocity. For details, see 4-5. Kick Velocity (page 47). 2-5. Reverb Steps: Hold down the Mode switch  [2]  [5]  Setting Setting Reverb effects add a warm ambience to sounds, simulating the complex reflections of actual performance spaces, such as a concert hall or a small club. Use the following procedure to select a reverb effect for the current kit. 1. Hold down the Mode switch to activate Menu Mode. 2. Press number button [2] to select the Kit Settings parameter group. 3. Press number button [5] to select the Reverb parame- ter. 4. Select a reverb effect using the corresponding number button [1] to [10]. Number button [1] [2] [3] [4] [5] [6] [7] [8] [9] [10] Setting Off Hall Studio Room 1 Room 2 Stage Small Stage Plate Early Reflection Gate Reverb 44 DTX402K DTX432K DTX452K Owner's Manual