Yamaha DTX500 Owner's Manual - Page 36

8 Trigger Setup Edit DT LoTom DT series drum trigger (for a large toms) DT Kick DT series drum trigger (for a bass drum) misc~1-6 Other manufacturer's pads 1 to 6 *1 These pad types are different in the sensitivity settings among the three sections (the Bow section, Edge section, and Cup section in 3-zone cymbal pad.) You can change these as desired. "CY-1" is the setting that the sensitivities of the three sections are same. "CY-2" is the setting that the sensitivity of the Edge section is set fairly lower than the other section. "CY-3" is the setting that the sensitivity of the Cup section is set fairly lower than the other section. TRG3 Gain, MVI (Minimum Velocity) TRG3~ ƒsnare~~0% "Gain=65MVl=~12, Gain [Range] 0-99 Adjusts the input gain (sensitivity) for the input jack assigned in the upper half of the page. Setting a larger value lets a smaller input level from the pad create sound. * This value will be automatically set after the appropriate pad type is set in [TRG2 Type (Pad Type)]. Some fine-tuning of the value will be necessary. * Some pads are equipped with a sensitivity adjustment knob. For details, refer to the owner's manual that came with the particular pad. MVI [Range] 1-127 Sets the MIDI Velocity (volume) that is transmitted when the pad is hit the softest. Large values will produce a high volume level even if the pad is hit softly. However, this will result in a narrow volume range making it difficult to adequately produce wider dynamic levels. The Trigger Input Level will be displayed in percentage in the upper right hand corner of the display. The maximum velocity (input level 99 percent) will be 127. The lower the level is when the pad is hit the weakest, the wider the potential dynamic range will be. * This value is automatically set after the appropriate pad type is set in [TRG2 Type (Pad Type)]. Some fine-tuning of the value will be necessary. Velocity → TRG4 VelCurve (Velocity Curve) TRG4~ ƒsnare~~0% "VelCurve=norm~, Sets the Input Velocity Curve for the input jack assigned in the upper half of the page. norm loud2 loud1 hard1 hard2 Strength of hit → TRG5 RejTime (Self Rejection Time) TRG5 ~ƒsnare~~0% "~~RejTime=1~~~, [Range] 0-9 Prevents double triggering from occurring in the input jack assigned in the upper half of the page. After an event is detected, further events will be automatically muted for a certain length of time. The larger the value, the longer time events will be muted. TRG6 RejLvlAll (Rejection Level) TRG6 ~ƒsnare~~0% "~RejLvlAll=2~~, [Range] 0-9 Prevents crosstalk from occurring in the input jack assigned in the upper half of the page. Events triggered by other pads (input jacks) that are of a lower input value than what is set here will not be triggered for a certain length of time. Larger values require a greater input level in order to produce a trigger event. 36 DTX500 Owner's Manual