Yamaha DTX900 Owner's Manual - Page 16
Setting Up, Connecting the Pads - dtx900k
UPC - 086792939285
View all Yamaha DTX900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Setting Up IMPORTANT You'll need to change the Trigger Settings of the DTX900 according to the type of drum set you are using (Standard Set/Special Set/Acoustic Drums, etc.). If the setting is not appropriate, problems may occur-such as improper sound, or inappropriate volume balance among the pads. Refer to the "Selecting the Trigger Setup" section on page 22 on how to select the appropriate setup. Connecting the Pads Referring to the illustration below, connect the output cable from each pad to each Trigger Input jack located on the rear panel of the DTX900. All Trigger Input jacks are conveniently labeled (1 SNARE, etc.), so make sure each pad is connected to its corresponding Trigger Input jack. WARNING • To prevent electric shock and damage to the devices, make sure the power is switched OFF on the DTX900 and all related devices before making any connections to the DTX900's input and output jacks. ■ DTX900K DTX900 Attaching the module stand Attach the included module stand to the DTX900 using the module stand fastening screws. * Be sure to use the included screws. Module stand (included) NOTE • The pad models described in the illustrations were included in the Standard Set/Special Set at the moment this Owner's Manual was produced. Keep in mind that the model names of your Standard Set or Special Set may be different from the ones illustrated here. For details about the latest information on Yamaha drum pads, refer to the following website. http://www.yamaha.co.jp/english/product/drums/ed/ Module stand fastening screws x 4 (included) DTX900 RHH135 to 9HI-HAT to HI-HAT CONTROL * First, connect the RHH135's [PAD] output jack to the 9HIHAT jack on the DTX900, then connect the RHH135's [HI-HAT CONTROL] output jack to the HI-HAT CONTROL jack on the DTX900. PCY135 to 7CRASH to 2TOM1 to 3TOM2 PCY155 to 6RIDE XP100T XP100T PCY135 to 8CRASH2 XP120SD KP125W XP100T to 4TOM3 to 1SNARE * Foot pedal is not included in the Standard Set. to JKICK/K 16 DTX900 Owner's Manual