Yamaha DXS12 Owner's Manual - Page 7
Controls and Functions, Rear panel, INPUT jacks, THRU jacks, LEVEL control, LIMIT indicator - dxs 12
View all Yamaha DXS12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
English Controls and Functions Controls and Functions Rear panel ! DXR15, DXR12, DXR10, DXR8 INPUT jacks These are balanced XLR input jack(s) (INPUT 1), unbalanced phones (INPUT 2) and RCA pin input jacks (INPUT 3). You can connect a mixing console or microphone to INPUT 1, a keyboard or electric-acoustic guitar to INPUT 2, and a portable audio player or CD player to INPUT 3. Signals from INPUT 1-3 are mixed inside the DXR unit. The DXS series input features only balanced XLR input jacks (L, R). L and R signals are mixed inside the DXS unit. THRU jack(s) These are balanced XLR output jack(s). Input signals will be passed through unaffected, since these are parallel connected to the INPUT jacks. LEVEL control Adjusts the level of each INPUT signal. If you connect a device that features a nominal output level of +4dBu (such as a mixing console), set the MIC/LINE switch () on the DXR series to LINE, and adjust the LEVEL control using its 12 o'clock position as a reference. LIMIT indicator Lights when the output limiter is active. The output limiter will operate in order to protect the speaker and amp, attenuating the output signal to the amplifier. If this indicator stays lit, lower the level of the input signal. ? DXS15, DXS12 NOTE • If the output voltage of the amplifier has exceeded the maximum value, or if excessive integral power consumption is detected, the LIMIT indicator will light when the amount of attenuation is 3dB or higher. • The integral power consumption refers to the sum of power consumption provided to the speaker driver per unit time. SIGNAL indicator Lights when an audio input signal is detected. PROTECTION indicator Lights when the protection system is active. The protection system will operate and the speaker output will be muted in the following situations. • If amplifier overheating is detected: • If DC output is detected: • If overcurrent is detected: • When turning the power on: The protection system will be activated to prevent noise and the indicator will light for about two seconds. The indicator turns off when the power supply has started normally. • When turning the power off: Or if the power turns off due to an unexpected error, the protection system will be activated to prevent noise, and then the power will be shut down. NOTE If the protection system has engaged after the problem was detected, waiting until the amplifier cools down or powering off and on again will return to normal operation. If the unit does not return to normal operation, please contact your Yamaha dealer. DXR15/DXR12/DXR10/DXR8/DXS15/DXS12 Owner's Manual 7