Yamaha E1005 E1005 Owners Manual Image - Page 3

GENERAL SPECIFICATIONS DELAY TIME (Continuously variable within each range) FEEDBACK MODULATION OUTPUT (Mixing & Direct) DELAY OUTPUT INDICATORS POWER REQUIREMENTS DIMENSIONS NET WEIGHT Short range, 4 msec. to 9msec. Long range, 65 msec. to 400 msec. Variable, from none to 100%. Sinusoidal variation of delay time relative to set delay. SPEED (frequency) from 0.5 to 10Hz. DEPTH from 0 to 10% @ short range, or from 0 to 30% @ long range. FREQUENCY RESPONSE: 20Hz - 20kHz 3dB, -20dB input level. TOTAL HARMONIC DISTORTION: Less than 0.3%, 20Hz - 20kHz, @-10dB* output into 10kg. INTERMODULATION DISTORTION: Less than 1%, using frequencies of 70Hz & 7kHz, mixed 4:1, @-10dB* output into 10kO. NOISE **: -110dBm equivalent input noise, -80dB* output noise with Input A volume at maximum, Input B at minimum. TOTAL HARMONIC DISTORTION: Less than 3%, @-10dB* output into 10kI-2. INTERMODULATION DISTORTION: Less than 5%, using frequencies of 70Hz & 7kHz, mixed 4:1, @-10dB* output into 10Idt. NOISE **: -80dB* output noise either delay range. POWER ON: LED turns ON when Power is ON. INPUT LEVEL: 5-segment LED display shows peak input level in dB(relative). Calibrated in steps of +2, 0,-3, -7, -15dB. 120 V AC (nominal, ±10%), 60Hz, 12 watts. 3-2/3" high x 15-1/2" wide x 8-1/3" deep (95 x 396 x 213mm), including feet. 8 pounds (3.6 kg). INPUT CHARACTERISTICS ACTUAL LOAD CONNECTION IMPEDANCE INPUT A 25kS2 INPUT B INST. INPUT B MIC. 500k12 25k11 FOR USE WITH NOMINAL 150 to 5k,S2 MICROPHONE 5kS2 LINE & INSTRUMENT 150 to 5k2 MICROPHONE OUTPUT CHARACTERISTICS SENSITIVITY -50dB -30dB -50dB INPUT LEVEL NOMINAL MAX. BEFORE CLIP -50dB -22dB -30dB -2dB -50dB -22dB Terminals Phone Jack (Unbalanced) CONNECTION ACTUAL SOURCE IMPEDANCE OUTPUT 2502 DELAY ONLY 2502 * 0dB is referenced to 0.775 Vr.m.s. ** Compensated with -6dB/octave filter @ 12.47kHz. Specifications are subject to change without notice. FOR USE WITH NOMINAL 10I