Yamaha E1005 E1005 Owners Manual Image - Page 6
Setup
View all Yamaha E1005 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
SETUP HINTS FOR QUICK SETUP Plug the cable from your microphone into the Input A or Input B jack (switched to Mic position); instrument or mixer effects outputs can only be connected to Input B (switched to Inst position). Connect a cable from the E1005's Output jack (generally not the "Delay Only" output) into the input jack of your amplifier, mixer, tape machine, etc. Then set up the El 005 for the desired effect, refering to the diagrams on page 5 of this manual. If you don't hear any sound right away, check the E1005 Power switch and Input level control (s), and make sure that the display is active during louder passages. Be sure the input and output cables are connected properly. Also, check the AC power cord and outlet. TYPICAL HOOKUPS The following illustrations are typical applications of the El 005. Suggested control settings for obtaining various effects are illustrated in Figure on page 7. BASIC SETUP 1. Basic setup for using a microphone, an instrument, both a mic and an instrument, or two microphones to feed the E1005 input(s), and connecting the El 005 Output to an instrument amplifier. (Note that in this setup, the E1005 Mixing control should be set for the desired ratio of direct and delayed signal.) - ®!YAMAHA E:= '0 • ° . - ,.. ,..- te . ---- - - - • • . OD OD mic I AND OR MIC OR INSTRUMENT M. .1 CONNECTIONS AND BASIC CONTROL SETTINGS Signal Source Input A Control 1 microphone (use Input A) 1 instrument (use Input B) 2 microphones (use Input A & Input B) 1 microphone (use Input A) & 1 instrument (use Input B) as required #0 as required for mic "A" as required for mic level using only 5 TO INSTRUMENT AMPLIFIER INPUT JACK Input B Control #0 as required as required for mic "B" as required for instrument level Mic/lost Sw. no effect Inst Mic Inst