Yamaha EMX3000 Owner's Manual - Page 7

Control panel 3 s Master control section In this section, you can adjust the final level of the outputs. AFL AFL AFL AFL AFL J 0 0 0 0 0 5 5 5 5 5 10 10 10 10 10 15 15 15 15 15 20 20 20 20 20 25 25 25 25 25 30 30 30 30 30 40 40 40 40 40 50 50 50 50 50 MONI 1 MONI 2 EFFECT ST 1 MONO E F G H I E MONI 1 (monitor 1) fader The MONI 1 fader adjusts the final level of the signal sent from the MONITOR 1 bus to the MONI 1 jack (input/output panel 9). If the Power amp select switch V is set to MONI 1MONO, using this fader enables you to adjust the level of the signal sent from the SPEAKER L/ MONI1 1/2 jacks to the speakers. F MONI 2 (monitor 2) fader The MONI 2 fader adjusts the final level of the signal output from the MONITOR 2 bus to the MONI 2 jack (input/output panel 9). G EFFECT fader The EFFECT fader adjusts the final level of the signal output from the EFFECT bus to the EFFECT jack (input/output panel A). Note: The setting of this fader does not affect the level of the signal sent from the EFFECT bus to the built-in effect. H ST 1 (stereo 1) fader The ST 1 fader adjusts the final level of the signal sent from the STEREO bus to the ST 1 jacks (input/output panel 8). If the Power amp select switch V is set to ST1 L-ST1 R, this fader also adjusts the level of the signal sent to the SPEAKERS jacks (rear panel 1). Note: The setting of this fader does not affect the signal output from the STEREO bus to the ST 2 jacks. I MONO (monaural) fader The MONO fader adjusts the final level of the monaural signal output from the STEREO bus to the MONO jack (input/output panel 0). If the Power amp select switch V is set to MONI 1-MONO, this fader also adjusts the level of the signal sent from the SPEAKERS R/MONO 1/2 jacks to the speakers. If the Power amp select switch V is set to MONO (BRIDGE), this fader adjusts the level of the signal sent from the SPEAKERS BRIDGE jack to the speaker. J AFL (after fader listen) When this switch is on, the output signal that passes through the corresponding fader is sent to the C-R/PHONES jack (input/output panel B). Use these switches when you wish to monitor a particular output signal through the headphones. s Tape in section In this section, you can adjust the input level of a cassette deck or a CD player that is connected to the TAPE jacks (input/output panel 5). ST 0 10 PFL TAPE IN K L K ST (stereo) control This knob adjusts the level of the signal sent from the TAPE jacks to the STEREO bus. L PFL (pre-fader listen) switch When this switch is on, the signal input from the TAPE jacks is routed at the point before the ST control K to the C-R/PHONES jack (input/output panel B). EMX3000-Owner's Manual