Yamaha EMX5000-12 Owner's Manual - Page 14
Master control TR IN PFL pre-fader listen switch, AUX 1 fader, MONO OUT fader
View all Yamaha EMX5000-12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
12 Front and rear panel G PFL (pre-fader listen) switch When this switch is turned on, the signal at the point before the ST control knob F is sent to the PHONES jack (input/output panel D). Note: The ST control setting does not affect the level of the signal sent to the PFL/AFL buses (pre-fader send). s Master control section In this section, you can adjust the final level of the outputs. L H I J K H AUX 1 fader The AUX 1 fader adjusts the final level of the signal sent from the AUX 1 bus to the AUX SEND 1 jack (input/output panel 8). If the Power amp select switch Y is set to AUX 1-MONO, using this fader enables you to adjust the level of the signal sent from the SPEAKERS A 1/2 jacks to the speakers. I AUX 2 fader The AUX 2 fader adjusts the final level of the signal output from the AUX 2 bus to the AUX SEND 2 jack (input/output panel 8). If the Power amp select switch Y is set to AUX 1AUX 2, using this fader enables you to adjust the level of the signal sent from the SPEAKERS B 1/2 jacks to the speakers. J MONO OUT fader The MONO OUT fader adjusts the final level of the monaural signal output from the STEREO bus to the MONO OUT jack (input/output panel C). If the Power amp select switch Y is set to AUX 1MONO, this fader also adjusts the level of the signal sent from the SPEAKERS B 1/2 jacks to the speakers. If the Power amp select switch Y is set to MONO BRIDGE, this fader adjusts the level of the signal sent from the SPEAKERS A 1 jacks to the speaker. K ST OUT fader The ST OUT fader adjusts the final level of the signal sent from the STEREO bus to the ST OUT jacks (input/output panel 0). If the Power amp select switch Y is set to ST L-R, this fader also adjusts the level of the signal sent to the SPEAKERS jacks (rear panel 3). Note: The setting of this fader does not affect the signal output from the STEREO bus to the ST SUB OUT jacks. L AFL (after fader listen) switch When this switch is on, the output signal that passes through the corresponding fader is sent to the PHONES jack (input/output panel D). Use these switches when you wish to monitor a particular output signal through the headphones. s 2TR IN section In this section, you can adjust the input level of a cassette deck or a CD player that is connected to the 2TR IN jacks (input/output panel 5). M N M ST (stereo) control This knob adjusts the level of the signal sent from the 2TR IN jacks to the STEREO bus. N PFL (pre-fader listen) switch When this switch is on, the signal input from the 2TR IN jacks is routed at the point before the ST control M to the PHONES jack (input/output panel D). EMX5000-20/EMX5000-12-Owner's Manual