Yamaha EMX860ST Owner's Manual - Page 21

Specifications 21 Specifications s General specifications Maximum output power Frequency response Total harmonic distortion Hum & noise (Average, Rs=150Ω) (with 20 Hz-20 kHz BPF) Maximum voltage gain (PAD: OFF) Crosstalk at 1 kHz Input channel equalization Meters Graphic equalizer Internal digital effect Phantom power Limiter MAIN STEREO: 135 W+135 W/8Ω @0.5% THD at 1 kHz, 200 W+200 W/4Ω @0.5% THD at 1 kHz MAIN BRIDGE: 400 W/8Ω @0.5% THD at 1 kHz MONITOR: 135 W/8Ω @0.5% THD at 1 kHz, 200 W/4Ω @0.5% THD at 1 kHz 20 Hz-20 kHz +1 dB, -3 dB @1 W output into 8Ω (POWER AMP OUT) 20 Hz-20 kHz +1 dB, -3 dB @+4 dB output into 10 kΩ (MAIN OUT, MONITOR OUT, EFFECT OUT) Less than 0.5% @20 Hz-20 kHz, 100 W output into 4Ω (POWER AMP OUT) Less than 0.3% @20 Hz-20 kHz, +14 dB output into 10 kΩ (MAIN OUT, MONITOR OUT, EFFECT OUT) -125 dB equivalent input noise, -68 dB residual output noise (POWER AMP OUT) -95 dB residual output noise (MAIN OUT, MONITOR OUT, EFFECT OUT) -80 dB (MAIN OUT) Master level control: nominal level, All channel level controls: minimum -75 dB (MONITOR OUT) Master level control: nominal level, All channel level controls: minimum -71 dB (MAIN OUT) Master level control: nominal level, 1 channel level control: nominal level -84 dB (EFFECT OUT) Master level control: nominal level, All channel level controls: minimum -64 dB (EFFECT OUT) Master level control: nominal level, 1 channel level control: nominal level 86 dB CH IN (Lo-Z) to POWER AMP OUT (CH1-6) 66 dB CH IN (Lo-Z) to MAIN OUT, MONITOR OUT (CH1-6) 72 dB CH IN (Lo-Z) to EFFECT OUT (CH1-6) 48 dB CH IN (Lo-Z) to REC OUT (CH1-6) 56 dB CH IN (Hi-Z) to MAIN OUT, MONITOR OUT (CH1-6) 26 dB AUX IN to MAIN OUT 24 dB TAPE IN to MAIN OUT 66 dB MIC IN to MAIN OUT (CH7-8) 26 dB LINE IN to MAIN OUT (CH7-8) -65 dB adjacent input, -65 dB input to output ±15 dB Maximum HIGH 10 kHz shelving MID 2.5 kHz peaking LOW 100 Hz shelving * Turn over/roll-off frequency of shelving: 3 dB below maximum variable level. 5 POINTS LED METER (MAIN OUT L/R, MONITOR OUT) 7 bands (125, 250, 500, 1k, 2k, 4k, 8k Hz) ±12 dB Maximum (MAIN OUT, MONITOR OUT) 3 types (Vocal, L Hall, S Hall) +48 V is supplied to electrically balanced inputs for powering condenser microphones via 6.8 kΩ current limiting/isolation resisters. Comp. : THD≥0.5% (MAIN, MONITOR) LIMIT indicators Turns on. : THD≥0.5% (MAIN, MONITOR) Foot switch DIGITAL EFFECT MUTE : on/off Optional accessories Power requirement Power consumption FC5 Foot switch USA and Canada Europe Other 300 W 120 V AC 60 Hz 230 V AC 50 Hz 240 V AC 50 Hz Dimensions (WxHxD) 497×324×275 mm Weight 17 kg EMX860ST-Owner's Manual