Yamaha FX500 FX500 Owners Manual Image - Page 22
Control, Change, Number, Controller, Assignment, specific, controller, assigned., WHEEL, BREATH,
View all Yamaha FX500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
In order to use this kind of setup, the two "controllers" that the FX500 allows - CONTROLLER 1 and CONTROLLER 2 - must be set to receive specific MIDI CONTROL CHANGE data (i.e. receive data from a specific MIDI controller) using the Control Change 1 Table Edit and Control Change 2 Table Edit functions described below. • Control Change 1 Table Edit When this function is called the LCD appears as shown below, and the Aand Vkeys can be used to select the desired MIDI control change number for controller 1. ,..00 IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII 65 CONTROLLER 1 1 NOD. WHEEL IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII ® e±'1, O da as CONTROLLER 1 1 MOD. WHEEL The following control change numbers and associated controllers (or none of no controller is specifically assigned) can be selected: Control Change Number Controller Assignment OFF 0 1 2 3 4 5 6 7 8-31 64 65 66 67 68 - 95 102 - 114 Controller OFF No specific controller assigned. MOD. WHEEL BREATH CTRL No specific controller assigned. FOOT CTRL PORT TIME DATA ENTRY MAIN VOLUME No specific controller assigned. SUST SWITCH PORT SWITCH SUST PEDAL SOFT PEDAL No specific controller assigned. No specific controller assigned. Press the STORE key to directly assign "OFF". Two other control sources which are not directly associated with MIDI control change numbers can also be selected: NOTE al VELCTY (key velocity, an integral part of MIDI NOTE ON data), and CHANNEL PRESS (channel pressure). 21 If NOTE ON VELCTY is assigned and a number of NOTE ON messages are received simultaneously (e.g. a chord is played), the NOTE message with the highest note number takes priority. NOTE: The FX500 only receives control change data on the MIDI channel specified using the MIDI Setup function. • Control Change 2 Table Edlt This function operates in exactly the same way as Control Change 1 Table Edit, above. The LCD appears as shown below, and the Aand Vkeys can be used to select the desired MIDI control change number for controller 2. as CONTROLLER 2 2 BREATH CTRL NOTE: The control number assigned to controller 1, also can be assigned to controller 2. • Assigning CONTROLLER 1 and CONTROLLER 2 to Specific Effects 7/ alum, so. S CTRL1 NIN-MAX VOLUNE 0 100 // IIIIIIIIIOIgIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII T E5 ooa, Oro cc7O5c.5 at'a•aa ® Once the MIDI controllers you wish to use have been selected using the Control Change 1 Table Edit and Control Change 2 Table Edit functions described above, you can then assign the controllers to the specific FX500 effect parameters. Control assignment is carried out in the PARAM mode. 0 First select the appropriate effect in the MEMORY mode, then activate the parameter mode by pressing the PARAM key (of course, this step is not necessary if you're already editing an effect in the parameter mode). 0 To assign CONTROLLER 1 to an effect parameter, press the SEL/ASN key in the parameter mode and a display similar to the following will appear. 85 CTRL1 MIN -MAX VOLUME 0 100