Yamaha GX-70 Owner's Manual - Page 36

TUNING OPERATION 4, 3 MINI COMPONENT SYSTEM GX-70 DISC CHANGE OPEN/CLOSE 1 2 DISC 3 PROGRAM MUSIC PRESET/TUNING/BAND CD A/B/C/D/E USER MEMORY POWER PHONES AUTO/MAN'L DOLBY NR INPUT DOWN INPUT UP TAPE 1/2 MODE REC/PAUSE TIMER REC NORMAL HIGH DUBBING TIMER HOUR MIN PLAYBACK 1 2 REC/PLAYBACK PTY SEEK FREQRAPSN/PDTYO/RMT/CT RMEOPDEEAT STEADRTIT DISPLAY VOLUME DOWN UP MEMORY TIME ADJ Active Servo Technology EJECT EJECT 3, 2 2 1 1 1 6 6 A TIME MODE CD 2 3 4 5 2 3 4 5 7 8 PRESET 7 8 9 0 B C D E PROG TAPE EDIT +I0 REPEAT RANDOM OPEN/CLOSE TUNER DISC SKIP STOP PLAY/PAUSE REC/PAUSE TAPE 1/2 PLAY STOP PLAY CENTER/ REAR / DELAY TEST FLAT TAPE LEVEL SLEEP MUSIC PROGRAM USER POWER VOLUME INPUT 1 "AM" is for U.S.A., Canada, Australia, China, Singapore and General models. "MW/LW" is for U.K. and Europe models. Normally, if station signals are strong and there is no interference, quick automatic-search tuning (Automatic tuning) is possible. However, if signals of the station you want to select are weak, you must tune to it manually (Manual tuning). Automatic tuning 1 Press the INPUT selector or button once or more so that "TUNER" appears on the display. 2 Select the reception band [FM or AM (MW or LW)] by pressing the PRESET/TUNING/BAND button confirming it on the display. * Do not select a preset tuning mode (in which "PRESET" lights up on the display.) 3 Press the AUTO/MAN'L button so that "AUTO" appears on the display. (In this mode, stations are received in stereo or monaural automatically.) 4 Press the button to tune to a higher frequency, or press the button to tune to a lower frequency. (When tuned in to a station, "TUNED" will light up on the display.) 5 If the station where tuning search stopped is not the desired one, follow step 4 again. * If the tuning search does not stop at the desired station, change to the Manual tuning method as described below. * STEREO indicator will light up when an FM stereo broadcast with sufficient signal strength is received. Manual tuning 1 Follow steps 1 and 2 of the Automatic tuning method. 2 Press the AUTO/MAN'L button so that "AUTO" disappears from the display. (In this mode, stations are received in monaural.) 3 Press and hold the button to tune to a higher frequency, or press and hold the button to tune to a lower frequency. Release it just before reaching the desired frequency, and then press it repeatedly until the desired frequency appears. (When tuned in to a station, "TUNED" will light up on the display.) Note If you tune in to an FM station manually, it is received in monaural automatically to increase the signal quality. Note Pressing the TUNER input selector button on the remote control transmitter switches the tuner from a normal tuning mode to a preset tuning mode and vice versa. E-24