Yamaha GX-70 Owner's Manual - Page 53

OTHER RECORDINGS 1 MINI COMPONENT SYSTEM GX-70 DISC CHANGE OPEN/CLOSE 1 2 DISC 3 PROGRAM MUSIC PRESET/TUNING/BAND CD A/B/C/D/E USER MEMORY POWER PHONES AUTO/MAN'L DOLBY NR INPUT DOWN INPUT UP TAPE 1/2 MODE REC/PAUSE TIMER REC NORMAL HIGH DUBBING TIMER HOUR MIN PLAYBACK 1 2 REC/PLAYBACK PTY SEEK FREQRAPSN/PDTYO/RMT/CT RMEOPDEEAT STEADRTIT DISPLAY VOLUME DOWN UP MEMORY TIME ADJ Active Servo Technology EJECT 4 5 EJECT 6, 1 3 7, 2 6, 1 1 1 6 6 A TIME MODE 2 2 7 7 B PROG REPEAT CD 3 4 5 3 4 5 8 PRESET 8 9 0 C D E TAPE EDIT +I0 RANDOM OPEN/CLOSE TUNER DISC SKIP STOP PLAY/PAUSE REC/PAUSE TAPE 1/2 PLAY STOP PLAY CENTER/ REAR / DELAY TEST FLAT TAPE LEVEL SLEEP MUSIC PROGRAM USER POWER VOLUME INPUT 1 General information • When recording important selections, be sure to make a preliminary test to ensure that the desired source material is being properly recorded with good sound quality. • The automatic recording level control circuit automatically controls the level of the input signal used for recording. • Adjusting the VOLUME control has no effect on the recorded sound. If, however, the built-in graphic equalizer and/or sound field processor is used, its effect is recorded along with the source. * Music with an equalizer effect is suitable for listening to inside a car etc. • For the tape deck, the deck which can be used for recording is deck 2 only. When recording, be sure to load a tape into the deck 2 cassette compartment. Recording from the built-in tuner 1 Press the INPUT selector or button once or more so that "TUNER" appears on the display. 2 Tune to the desired station. (Refer to the "TUNING OPERATION" on page 24 and 25.) 3 Load a tape into the deck 2 cassette compartment. 4 When recording with the Dolby NR system, press the DOLBY NR button so that " B" lights up on the display. If not, turn it off. * For details, refer to the "Dolby B Type Noise Reduction" on page 31. 5 Select the reverse mode " " to record on only one side, or " " for continuous recording on both sides by pressing the reverse MODE selector button. 6 Press the REC/PAUSE button. * "REC" lights up on the display. 7 Press the play button on the remote control transmitter to record on side A, or the play button to record on side B. * For continuous recording on both sides, begin on side A. Recording stops automatically at the end of side B. To stop recording temporarily 1 Press the REC/PAUSE button. 2 To resume recording, press the play button. To stop recording Press the stop button. To reduce beats during recording While recording an AM (long wave) broadcast, you may hear a bleep caused by beat frequencies. In such a case, pressing the TUNER input selector button on the remote control transmitter once or more will reduce or remove beats. (Whenever the TUNER input selector button is pressed, "B.C-1" and "B.C-2" appears on the display alternately. Select either of them in which you find that beats are more reduced.) E-41 English