Yamaha GX-70 Owner's Manual - Page 45

English TAPE DECK OPERATION Direct operation When the power is off (in the standby mode), pressing the TAPE 1/2 input selector button or the play button will turn the power on and start playback of the selected tape automatically. When the power is on, even if an input source other than tape deck is selected, pressing the play button (or the fast wind button) will start playback (or fast winding) directly. Notes • When removing the tape, press the stop button, and then open the cassette compartment. • Even if you press the TAPE 1/2 input selector button on the front panel or the TAPE 1/2 button on the remote control transmitter during playback, the playback of currently selected tape cannot be changed to the other one though the tape number indicator on the display changes. MINI COMPONENT SYSTEM GX-70 DISC CHANGE OPEN/CLOSE Winding the tape 1 If during playback, first press the stop button. 2 Next press the fast wind wind the tape. or fast wind button to 1 2 DISC 3 PROGRAM MUSIC PRESET/TUNING/BAND CD A/B/C/D/E USER MEMORY POWER PHONES AUTO/MAN'L DOLBY NR INPUT DOWN INPUT UP TAPE 1/2 MODE REC/PAUSE TIMER REC NORMAL HIGH DUBBING TIMER HOUR MIN PLAYBACK 1 2 REC/PLAYBACK PTY SEEK FREQRAPSN/PDTYO/RMT/CT RMEOPDEEAT STEADRTIT DISPLAY VOLUME DOWN UP MEMORY TIME ADJ Active Servo Technology EJECT EJECT 1 1 6 6 A TIME MODE 2 2 7 7 B PROG REPEAT CD 3 4 5 3 4 5 8 PRESET 8 9 0 C D E TAPE EDIT +I0 RANDOM OPEN/CLOSE TUNER DISC SKIP STOP PLAY/PAUSE REC/PAUSE TAPE 1/2 PLAY STOP PLAY CENTER/ REAR / DELAY TEST FLAT TAPE LEVEL SLEEP MUSIC PROGRAM USER POWER VOLUME INPUT 3 Press the stop Moves rapidly in the direction of the current playback while searching. button to stop. Note When the tape is wound to the end, this unit will then function as described below, according to the setting of the reverse MODE selector button. : The tape stops at the end. : When the tape reaches the end, playback automatically starts from the reverse side. Searching for the beginning of a desired selection Carry out the following operation during playback to find the beginning of a desired selection on the tape. To listen to the same selection Press the button if the direction of the current playback is . Press the button if the direction of the current playback is . To listen to the next selection Press the button if the direction of the current playback is . Press the button if the direction of the current playback is . Flashes on and off. Moves rapidly in the direction of the current playback while searching. Notes • This function may not work for tapes with * Material with long pauses or quiet passages. * Low recording levels or excessive noise. * Pauses of less than 4 seconds between selections. • If searching is carried out at the first or the last part of a selection, the desired selection may not be found. E-33