Yamaha GX-707 Owner's Manual - Page 40

Recording STANDBY / ON STANDBY TIMER INPUT PRESET/TUNING/BAND A/B/C/D/E / PROGRAM B.BOOST MUSIC UP DOWN VOLUME PHONES BASS TREBLE MODE DOLBY NR REC/ PAUSE AUTO/ MANUAL MEMORY RANDOM REPEAT TIME DISPLAY TIMER TIME ADJ HOUR MIN DIRECTION 1 TIME 9 POWER TIME 1 2 3 1 2 3 4 5 6 4 5 6 7 8 9 7 8 0 TUNER +I0 PRESET PRESET TIME PROG R.TIME A EDIT B C DISC SKIP MODE D E CD / 5 7 3 4 DIRECTION TAPE REC/ PAUSE TEST - LEVEL CENTER / REAR/ DELAY PROGRAM MUSIC SLEEP INPUT 1 VOLUME Display information during programming Next play order Selected disc TRACK NR CD 123456 7 8 9 10 11 12 13 14 15 OVER 15 A PROG V Side of the tape Selected track number Total remaining time on this side of the tape TRACK REM E-30 NR CD 123456 7 8 9 10 11 12 13 14 15 OVER 15 A PROG V Programmed track numbers light up and only programmable track numbers among unprogrammed ones flash. s Manual EDIT recording You can program tracks manually while watching the remaining time on both sides of the tape. 1 Press INPUT or repeatedly until "CD" (1) appears on the display, and load a disc (or discs) on the disc tray. 2 Follow steps 3-5 on page 28. 3 Press PROG. * "PROG" and "P-01" will light up on the display, and all track numbers on the selected disc will begin blinking. 4 If necessary, select the desired disc by pressing DISC SKIP. 5 Select the desired track number by pressing the numeric buttons. 6 Repeat steps 4 and 5 to program more selections for side A of the tape. You can select the same track again. * Pressing TIME displays the total remaining time on side A of the tape for about 1 second, and then it is replaced by the display of the next play order. * You can only select track numbers 1 through 15 for manual EDIT recording. All track numbers higher than 15 i.e.16, 17, 18... cannot be selected for recording even if there is recordable space available on the tape. "TM OVER" will appear on the display. At this time, however, if any other track number is flashing continuously on the display, you can program it instead of the unprogrammable one. 7 When the programming for side A is finished, press R. TIME. * "Side-B" appears on the display. You can begin programming for side B. * After following this step, you can check the programmed contents for side A and side B alternately by pressing R. TIME at any time before you press EDIT in step 9. * The tape side indicator (9) shows the programming side currently selected. 8 Repeat steps 4 and 5 to program selections for side B of the tape. You can select the same track again. 9 Press EDIT. ("EDIT" (8) lights up on the display.) The recording begins. Note To check, cancel or correct program data, refer to page 16. To cancel the EDIT function Before recording, press on the CD player or the tape deck. To stop recording Press on the tape deck. (At this time, disc play automatically stops.) Notes on recording with the EDIT function • The maximum number of tracks that can be programmed is 20. • The track number 16 or higher cannot be programmed by this function. • The CD player's repeat play mode will be canceled during the recording mode.