Yamaha HTR-5250 Owner's Manual - Page 43
DELAY TIME AND SPEAKER OUTPUT LEVELS, Delay Time, Sound Output Level of the Center
View all Yamaha HTR-5250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
INTRODUCTION PREPARATION BASIC OPERATION ADVANCED OPERATION DELAY TIME AND SPEAKER OUTPUT LEVELS When using the digital sound field processor with the Dolby Pro Logic decoder, Dolby Digital decoder or DTS decoder, you can adjust the delay time between the main sound and sound effect, and each speaker's output level as you wish. Note • When high-rate 96-kHz sampling 24-bit digital signals are input to this unit, the delay time and speaker output levels cannot be adjusted. Delay Time You can adjust the time difference between the beginning of the sound from the main speakers and the beginning of the sound effect from the rear speakers. The larger the value, the later the sound effect is generated. The delay time can be individually adjusted to all DSP programs. Notes • Adding too much delay will cause an unnatural effect with some sources. • The sound is momentarily interrupted while adjusting the delay time. Program 1. PRO LOGIC/Normal DOLBY DIGITAL/Normal DTS DGTL SUR/Normal PRO LOGIC/ENHANCED DOLBY DIGITAL/ENHANCED DTS DGTL SUR/ENHANCED 2. 70 mm SPECTACLE DGTL SPECTACLE DTS SPECTACLE 70 mm SCI-FI DGTL SCI-FI DTS SCI-FI 3. 70 mm ADVENTURE DGTL ADVENTURE DTS ADVENTURE 70 mm GENERAL DGTL GENERAL DTS GENERAL 4. MONO MOVIE 5. TV SPORTS 6. DISCO 7. ROCK CONCERT 8. CONCERT HALL Control range (ms) 15 to 30 0 to 15 0 to 15 15 to 30 0 to 15 0 to 15 15 to 30 1 to 99 1 to 99 15 to 30 1 to 99 1 to 99 15 to 30 1 to 99 1 to 99 15 to 30 1 to 99 1 to 99 1 to 99 1 to 99 1 to 99 1 to 99 1 to 99 Preset value 20 5 5 20 5 5 23 15 15 20 16 16 20 15 15 20 15 15 49 9 40 16 44 Sound Output Level of the Center, Right Rear and Left Rear Speakers, and Subwoofer If desired, you can adjust the sound output level of each speaker even if it has already been adjusted in "ADJUSTING THE SPEAKER BALANCE" on pages 19 and 20. Notes • The sound output level of the center speaker cannot be adjusted when the input signal is analog, PCM audio, or encoded with Dolby Digital in 2-channel. • If "CENTER SP" on the SET MENU is set to the NONE position, the sound output level of the center speaker cannot be adjusted. This is because the center channel sound is automatically output from the right and left main speakers. • Once the sound output level has been adjusted, the level will be the same for all DSP programs. Speaker Center Right rear Left rear Subwoofer Control range (dB) MIN, -20 to +10 MIN, -20 to +10 MIN, -20 to +10 MIN, -20 to 0 Preset value 0 0 0 0 APPENDIX English 39