Yamaha HTR-5760 Owners Manual - Page 33

PREPARATION ■ Troubleshooting for auto setup procedure Before auto setup Error message Connect MIC! Cause Optimizer microphone is not connected. Unplug HP! Headphones are connected. AUTO SETUP Remedy • Connect the supplied optimizer microphone to the OPTIMIZER MIC jack on the front panel. • Unplug the headphones. Errors during auto setup Press SELECT to display detailed information about individual errors. Press j / i to switch between error messages. Error message E-1:NO FRONT SP E-2:NO SURR.SP E-3:NO PRES. SP E-4:SBR->SBL E-5:NOISY E-6:CHECK SURR. E-7:NO MIC E-8:NO SIGNAL E-9:USER CANCEL E-10:OTHER ERROR Cause Remedy Front L/R channel signal(s) is (are) not detected. • Select the front speakers with SPEAKER A or B. • Check the front left and right speaker connections. A surround channel signal is not detected. • Check the surround speaker connections. A presence channel signal is not detected. • Check the presence speaker connections. Only right surround back channel signal is detected. • Connect the surround back speaker to the LEFT SURROUND BACK SPEAKERS terminal if you only have one surround back speaker. Background noise is too loud. • Try the auto setup procedure in a quiet environment. • Turn off noisy electric equipment like air conditioners (etc.) or move them away from the optimizer microphone. Surround back speaker(s) is (are) connected, though surround L/R speakers are not. The optimizer microphone was unplugged during the auto setup procedure. • Connect surround speakers when you use (a) surround back speaker(s). • Do not touch the optimizer microphone during the auto setup procedure. The optimizer microphone does not detect test • Check the microphone setting. tones. • Check the speaker connections and placement. The auto setup procedure was cancelled due to user activity. A DSP communication error or hangup occurred. • Perform the auto setup procedure again. Do not adjust VOLUME (etc.) during the auto setup procedure. • Perform the auto setup procedure again. Warnings after auto setup Press j / i to display detailed information about individual warnings. Warning message W-1:OUT OF PHASE W-2:OVER 24m (80ft) W-3:LEVEL ERROR Cause Speaker polarity is not correct. This message may appear depending on the speakers even when the speakers are connected correctly. The distance between the speaker and the listening position is over 24 m (80 ft). Remedy • Check the speaker connections for proper polarity (+ or -). • Bring the speaker closer to the listening position. The difference of volume level among speakers is excessive. (No level correction is made.) • Readjust the speaker installation so that all speakers are set in locations with similar conditions. • Check the speaker connections. • Use speakers of similar quality and efficiency. • Adjust the output volume of the subwoofer. • If the ERROR or WARNING screens appears, check the cause of the problem, then perform the auto setup procedure again. • If warning W-1 appears, corrections are made, but they may not be optimal. • If warning W-2 or W-3 appears, no corrections are made. • If error E-10 occurs repeatedly, please contact a qualified YAMAHA service center. English 29