Yamaha HTR-5930 Owner's Manual - Page 37
Using Virtual CINEMA DSP, Listening to unprocessed input signals, For PRO LOGIC II Music
View all Yamaha HTR-5930 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
For 2CH STEREO: Direct DIRECT Function: 2-channel stereo direct. Bypasses the decoders and DSP processors of this unit for pure hi-fi stereo sound when playing Choices: 2-channel analog sources. AUTO, OFF y • The "AUTO" setting bypasses the decoders and DSP processors only when "BASS" and "TREBLE" are set to 0 dB (see page 24). • When multi-channel signals (Dolby Digital and DTS) are input, they are downmixed to 2 channels and output from the front left and right speakers. • The low-frequency signals input from the front left and right speakers are redirected to the subwoofer in the following cases: - "BASS" is set to "BOTH" (see page 54). - "FRONT" is set to "SML" (see page 54) and "BASS" is set to "SWFR" (see page 54). For PRO LOGIC II Music: Panorama PANORAMA Function: Sends stereo signals to the surround speakers as well as the front speakers for a wraparound effect. Choices: OFF, ON Dimension DIMENSION Function: Gradually adjusts the sound field either towards the front or towards the rear. Control range: -3 (towards the rear) to +3 (towards the front), initial setting is STD (standard). Center width CT WIDTH Function: Adjusts the center image from all three front speakers to varying degrees. A larger value adjusts the center image towards the front left and right speakers. Control range: 0 (center channel sound is output only from center speaker) to 7 (center channel sound is output only from front left and right speakers), initial setting is 3. SOUND FIELD PROGRAMS ■ Using Virtual CINEMA DSP Virtual CINEMA DSP allows you to enjoy the CINEMA DSP programs without surround speakers by creating virtual speakers. If you set "SURR" to "NONE" (see page 54), Virtual CINEMA DSP activates automatically whenever you select a CINEMA DSP program (see page 31). Note Virtual CINEMA DSP will not activate even when "SURR" is set to "NONE" (see page 54) in the following cases: - When "2CH STEREO" (see page 31) is selected or when this unit is in the "STRAIGHT" mode. - When the component connected to the MULTI CH INPUT jacks is selected as the input source (see page 25). - When headphones are connected to the PHONES jack. ■ Listening to unprocessed input signals When this unit is in the "STRAIGHT" mode, multichannel sources are decoded straight into the appropriate channels without any additional effect processing. 2channel stereo sources are output from only the front left and right speakers. 1 Press AMP on the remote control and then STRAIGHT to select "STRAIGHT". AMP STRAIGHT ENT. 2 To deactivate the "STRAIGHT" mode, press STRAIGHT on the remote control again so that "STRAIGHT" disappears from the front panel display. The sound field program is turned back on. y You can also select "STRAIGHT" by pressing STRAIGHT on the front panel. BASIC OPERATION 33