Yamaha HTR6280BL Owner's Manual - Page 16
together so that they will not cause a short, Loosen the knob, insert the twisted bare
UPC - 027108933603
View all Yamaha HTR6280BL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Connections Caution • A speaker cable is a pair of insulated cables running side by side in general. One of the cables is colored differently or striped to indicate a polarity. Connect one end of the colored/striped cable to the "+" (red) terminal of this unit and the other end to that of your speaker, and connect one end of the other cable to the "-" (black) terminal of this unit and the other end to that of your speaker. • Before connecting the speakers, be sure to disconnect the power cable. • Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or speakers. If the circuit shorts out, "CHECK SP WIRES!" appears on the front panel display when this unit is turned on. • If images on the monitor (CRT) are distorted, place the speakers away from the video monitor. If it does not work, use magnetically shielded speakers. • Use speakers with an impedance of 6-ohm or larger. Set speaker impedance in the advanced setup menu before connecting the speakers (page 65). You can also use 4-ohm speakers as the front speakers when you set "SP IMP." to "6ΩMIN". ■ Connecting speaker cables 1 Remove approximately 10 mm (0.4 in) of insulation from the end of each speaker cable and then twist bare wires of the cable together so that they will not cause a short circuits. ■ Using bi-amplification connections You can make bi-amplification connections to one speaker system which supports bi-amplification connection as shown below. To activate the connections, set "BI-AMP" to "ON" in the advanced setup menu (page 65). Front speakers Right Left 10 mm (0.4 in) 2 Loosen the knob, insert the twisted bare wires into the hole and then tighten the knob. This unit FRONT SURROUND BACK/ BI-AMP 2 1 3 Red: positive (+) Black: negative (-) Connecting the banana plug Tighten the knob and then insert the banana plug into the end of the terminal. Banana plug Caution Before making bi-amplification connections, remove any brackets or cables that connect a woofer with a tweeter. Refer to the instruction manuals of speakers for details. When not making bi-amplification connections, make sure that the brackets or cables are connected before connecting the speaker cables. Note • You cannot use surround back speakers or extra speakers (presence and Zone2 speakers) when bi-amplification connections are made. 12 En