Yamaha IM8-32 Owner's Manual - Page 17
STEREO MASTER GROUP OUT Jacks, PAN Controls, ON Switch/Indicator, Bus Assign Switches
View all Yamaha IM8-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
English 2 GROUP OUT Jacks These are TRS phone type impedance-balanced (page 19) output jacks that output the GROUP OUT signals. You can connect these jacks to a multi-track recorder, external mixer, or other such device. 3 PAN Controls These adjust the stereo position of the signals sent from GROUP OUT to the ST L/R bus. Rotate the knob clockwise to pan the signal right, and counter-clockwise to pan left. 4 ON Switch/Indicator When this switch is on, that GROUP OUT will be enabled and the indicator will light. 5 GROUP OUT Meter Three LEDs indicate the signal level after the GROUP OUT fader. The "-20" LED will light if the output signal level reaches -20 dB, and the "0" LED will light at nominal level. The PEAK LED will light red when the GROUP OUT signal reaches 3 dB before clipping. 6 Bus Assign Switches These switches assign the GROUP OUT signal to the ST L/R bus and the MONO bus. NOTE · Turn the ON switch on if you want to send the GROUP OUT signal to the ST L/R bus or MONO bus. 7 AFL Switch/Indicator When the AFL switch is on, the indicator will light and the signal after the GROUP OUT fader but before the ON switch is output to the MONITOR OUT and PHONES jacks for monitoring. NOTE · If you want to monitor the signal after the GROUP OUT fader, turn off all PFL switches. 8 GROUP OUT Fader Controls the level of the GROUP OUT signal. STEREO MASTER Section Rear Panel 1 2 3 4 5 6 7 Controls and Functions Top Panel 1 STEREO INSERT Jack This is an input/output jack located before the STEREO OUT master fader. You can connect a graphic equalizer or other signal processor. This is a TRS (tip, ring, sleeve) phone jack that carries both the send and return signal (tip = send/out; ring = return/in; sleeve = ground). Owner's Manual 17