Yamaha IM8-32 Owner's Manual - Page 18

English Controls and Functions NOTE · Patching external devices via an INSERT jack requires a special insert cable such as illustrated below (insert cable sold separately). To the input jack of the external processor To the INSERT jack Tip: OUT Sleeve (Ground) Ring: IN Tip: OUT Tip: IN To the output jack of the external processor 2 STEREO OUT Jacks These are XLR-3-32 type balanced output jacks that output the mixed stereo signal. They output the signal adjusted by the STEREO OUT master faders (7). Connect these jacks to the power amplifiers that drive your main speakers. 3 STEREO Level Meter These LEDs indicate the level of the signal sent to the STEREO OUT jacks. The "0" segment indicates the nominal output level. The PEAK segment lights red when the output approaches the clipping level. 4 ON Switch/Indicator When this switch is on, ST OUT will be enabled and the indicator will light. 5 PFL Switch/Indicator When the PFL switch is on, the indicator will light and the signal before the STEREO OUT master fader is output to the MONITOR OUT and PHONES jacks for monitoring. 6 AFL Switch/Indicator When the AFL switch is on, the indicator will light and the signal after the STEREO OUT master faders is output to the PHONES and MONITOR OUT jacks for monitoring. NOTE · If you want to monitor the signal after the STEREO OUT master faders, turn off all PFL switches. 7 STEREO OUT Master Faders These adjust the signal level sent to the STEREO OUT jacks. MONITOR Section Rear Panel Top Panel 1 Front Panel 2 3 4 5 6 1 MONITOR OUT Jacks These are impedance-balanced (page 19) TRS phonetype output jacks that you can connect to your monitor system. These jacks output the signal before or after the faders for the various buses. The PFL/AFL indicator (4) and the PFL and AFL indicators in each section indicate which signal is being output. NOTE · If both a PFL switch and AFL switch are on, the PFL switch will be enabled. If you want to monitor the signals after the faders, turn off all PFL switches. 2 PHONES Jack Connects a pair of headphones to this stereo phonetype output jack. These jacks output the signal before or after the faders for the various buses. 3 MONITOR Level Meter Indicates the level of the signal output to the MONITOR OUT and PHONES jacks. The "0" segment indicates the nominal output level. The PEAK segment lights red when the output approaches the clipping level. 4 PFL/AFL Indicator Indicates the signal sent to the MONITOR OUT and PHONES jacks. The PFL indicator will light when the signals before the faders (control) are being sent; the AFL indicator will light if the signals after the faders are being sent. 5 MONITOR Control Controls the level of the signal output to the MONITOR OUT jacks. 6 PHONES Control Controls the level of the signal output to the PHONES jack. 18 Owner's Manual