Yamaha MDX-E100 Owner's Manual - Page 16
ERASE, Disc Erase, Track Erase, Part Erase, Play the track containing the part you want
View all Yamaha MDX-E100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
ERASE The ability to erase sound without having to re-record is a convenient function of MD. You can erase the entire disc, a single track, or just part of a track. Disc Erase This operation lets you erase all audio and title (character) data to create a blank MD. Please note that once erased, this data can be recovered using the UNDO function. 1 Press & to set this unit to stop mode. 2 Press EDIT repeatedly to display "Disc Erase?", then press SET/ENTER. "DiscEraseOK?" appears in the display. 3 Press SET/ENTER again. When all audio, name and title data has been erased "Complete" appears momentarily. Track Erase This operation lets you erase a single track as well as corresponding title data. After you erase the track, the total number of tracks decreases by one and all tracks following that track are renumbered. Example: Erasing track 3 1 2 3 4 5 6 Before erasing A BCDE 1 2 3 4 5 6 After erasing ABDEF 1 Use $ or › to select the track you want to erase. 2 Press EDIT repeatedly to display "Erase ?", then press SET/ENTER. "(track number) Erase OK?" appears in the display. 3 Press SET/ENTER again. The track is erased and "Complete" appears momentarily. If you plan to erase two or more tracks To avoid confusion you should always erase from higher track numbers to lower track numbers. This prevents accidental renumbering of tracks you plan to erase. Part Erase This operation lets you erase part of a track. Erase Before erasing 1 A 2 3 B C 1 2 3 4 After erasing A1 A2 B C 1 Play the track containing the part you want to erase. 2 Use ! or ⁄ to locate the beginning of the part you want to erase (point A), then press * to pause at that point. 3 Press EDIT repeatedly to display "A-B Erase?", then press SET/ENTER. Point A (from step 2) is registered and "Erase A-_" appears in the display. 4 Use # and ⁄ to locate the end of the part you want to erase (point B). 5 Press SET/ENTER to register point B. "Check" appears, then the part you specified plays repeatedly and "Erase A-B?" appears in the display. To adjust points A and B Press EDIT repeatedly to display "A point" and "B point" alternately. Adjust the selected point by using $ or › in the direction you want to move the point. Each point can be adjusted up to 2 seconds in either direction. 6 Press SET/ENTER again. The part is erased and "Complete" appears momentarily. Notes • After part erase, a new track number is automatically assigned to the section starting after point B. • Point B cannot be positioned before point A. E-16