Yamaha MG32 MG32/14FX MG24/14FX Owners Manual - Page 21
Connector Polarities, ST INSERT I/O L, R Jacks, ST SUB OUT Jacks L and R, ST OUT Jacks L, R, MONO Jack
View all Yamaha MG32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Front & Rear Panels 7 ST INSERT I/O (L, R) Jacks These are balanced TRS (tip, ring, sleeve) phone-type bidirectional jacks. You use these jacks, for example, to connect to an external effector, submixer, or other such device. NOTE Connection to an INSERT I/O jack requires a special separately-sold insertion cable such as illustrated below. To the input jack of the external processor To the INSERT I/O jack Sleeve Tip Sleeve Ring Tip To the output jack of the external processor 8 ST SUB OUT Jacks (L and R) These are impedance-balanced phone output jacks. These jacks output a clone of the mixed stereo signal from the ST bus. The level for this output is adjusted by the ST SUB OUT control in the Master Control block (see page 13). You would typically use these jacks to connect to an external mixer or a supplementary SR system. NOTE The ST master fader does not operate on the signals from these jacks. Connector Polarities INPUT A, ST OUT, MONO Pin 1: Ground Pin 2: Hot (+) Pin 3: Cold (-) 9 ST OUT Jacks (L, R) These are balanced XLR output jacks. These jacks output the mixed stereo signal from the mixer's ST bus. The level for this output is adjusted by the ST master fader in the Master Control block (see page 13). You typically use the jacks to connect to your main output, such as to the power amplifiers driving your main speakers. 0 MONO Jack This balanced XLR input jack outputs a monaural mix of the stereo signal from the ST bus. The level for this output is controlled by the MONO fader in the Master Control block (see page 13). The output is a mix of the ST bus's L and R signals. A FOOT SWITCH TAP Jack This phone input jack is for connection to a foot switch, for use with the TAP DELAY feature. If you connect the (separately sold) YAMAHA FC5 foot switch to this jack and then set internal EFFECT 2 to [16] TAP DELAY, you can use the foot switch (as an alternative to the TAP button) to set the delay. The mixer will automatically set the delay to the interval between the last two taps. B POWER Switch Use this switch to turn the mixer's power ON and OFF. Press the switch in to set the power on ( ), and press again to set the power off ( ). C AC IN Connector Connects to the socket end of the AC power cord included with the mixer. INPUT OUTPUT MIC (Talkback) Pin 1: Ground Pin 2: Hot (+) Pin 3: Ground INPUT INPUT B, GROUP OUT, AUX SEND (1 to 6), EFFECT SEND (1, 2), ST SUB OUT* INSERT I/O, GROUP INS I/O, ST INSERT I/O PHONES Tip: Hot (+) Ring: Cold (-) Sleeve: Ground Tip: Output Ring: Input Sleeve: Ground Tip: L Ring: R Sleeve: Ground Ring Sleeve Tip Stereo channel input jacks, RETURN (1, 2) Stereo channel input jacks, 2TR IN, REC OUT Tip: Hot Sleeve: Ground Sleeve Tip Sleeve Tip *These jacks also accept connection to monaural phone plugs. If you use monaural plugs, the connection will be unbalanced. MG32/14FX, MG24/14FX 21