Yamaha MG32 MG32/14FX MG24/14FX Owners Manual - Page 7
Connecting to Power, Setting Up, mixer's channel faders and master control faders are set all - 14fx mixer
View all Yamaha MG32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Introduction Connecting to Power (1) Be sure that the mixer's power switch is off ( ). (2) Connect the socket end of the power cord to the AC IN connec- tor on the rear of the mixer. (3) Plug the other end of the power cord into a standard household power outlet. Be sure to unplug the power cord from the outlet if you are not going to use the mixer again for an extended period, and whenever there are lightning storms in the area. Setting Up (1) Before connecting to microphones and instruments, be sure that all devices are turned off. Also be sure that all of the mixer's channel faders and master control faders are set all the way down. (2) For each connection, connect one end of the cable to the relevant microphone or instrument and connect the other end to the appropriate input jack on the mixer. NOTE On each monaural channel, you may use either INPUT A or INPUT B, but not both. On stereo channels that provide both a phone input jack and an RCA-pin input jack, you may use either of these but not both. Please connect to only one of these jacks on each channel. (3) Power up the devices in the following order: Peripheral devices → mixer → power amps (or powered speakers). NOTE When shutting the system down, turn off the power in the opposite order: Power amps (powered speakers) → mixer → peripheral devices. Do not block the vents. Vent holes are located on the top, bottom, front, rear, and sides of this machine. All vent holes must remain unblocked to prevent overheating. 7 MG32/14FX, MG24/14FX