Yamaha MRX-100 MRX-100 OWNERS MANUAL - Page 14

English

Get Yamaha MRX-100 PDF manuals and user guides View all Yamaha MRX-100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

ENGLISH Symptom ERROR/ BATT. indicator status Possible Cause Program- Blinks Batteries are nearly exhausted. ming is three times completed, but the object component does not Noise has been learned together with the object signal. work. Incorrect signal is stored. / If a signal, such as for the power switch, has been stored by pressing the button twice in a very short interval, the power of the object component may be turned ON, then OFF immediately. Remedy Replace the batteries of the MRX-100 with new ones. Perform the programming operation again. Perform the programming operation again. The remote sensor of the object component is obstructed. Remove the obstacle so as not to block the remote sensor. The object component has a remote sensor with an ability which is too low to receive the infrared signal from the MRX-100 at a distance. Operate from a closer position. Continuous operations, such as the volume control or picture search of a VCR, is impossible. Operation is possible only non-continuously. / If the object key is pressed momentarily during a learning operation, it may be stored as a single (non-continuous) signal. Keep pressing the required key on the object remote controller until the PUSH OTHER KEY indicator goes out. Perform the programming operation again. . 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
ENGLISH
Symptom
ERROR/
BATT.
indicator
status
Possible
Cause
Remedy
Program-
ming
is
completed,
but
the
object
component
does
not
work.
Blinks
three
times
Batteries
are
nearly
exhausted.
Replace
the
batteries
of
the
MRX-100
with
new
ones.
Noise
has
been
learned
together
with
the
object
signal.
Perform
the
programming
operation
again.
Incorrect
signal
is
stored.
/
If
a
signal,
such
as
for
the
power
switch,
has
been
stored
by
pressing
the
button
twice
in
a
very
short
interval,
the
power
of
the
object
component
may
be
turned
ON,
then
OFF
immediately.
Perform
the
programming
operation
again.
The
remote
sensor
of
the
object
component
is
obstructed.
Remove
the
obstacle
so
as
not
to
block
the
remote
sensor.
The
object
component
has
a
remote
sensor
with
an
ability
which
is
too
low
to
receive
the
infrared
signal
from
the
MRX-100
at
a
distance.
Operate
from
a
closer
position.
Continuous
operations, such
as
the
volume
control
or
picture
search
of
a
VCR,
is
impossible.
Operation
is
possible
only
non
-continuously.
/
If
the
object
key
is
pressed
momentarily
during
a
learning
operation,
it
may
be
stored
as
a
single
(non
-continuous)
signal.
Keep
pressing
the
required
key
on
the
object
remote
controller
until
the
PUSH
OTHER
KEY
indicator
goes
out.
Perform
the
programming
operation
again.
.
13