Yamaha MW10 Owner's Manual - Page 16

English Front & Rear Panels Master Control Section 8 1 2 7 3 4 6 5 1 PHANTOM +48 V Switch This switch toggles phantom power on and off. If you set the switch on, the mixer supplies power to all channels that provide XLR mic input jacks (CHs 1, 2, 3/4, 5/6). Set this switch on ( ) when using one or more condenser microphones. n When this switch is on, the mixer supplies DC +48 V power to pins 2 and 3 of all XLR-type MIC INPUT jacks. • Be sure to leave this switch off ( ) if you do not need phantom power. • When tuning the switch on ( ), be sure that only condenser mics are connected to the XLR input jacks (CHs: 1 to 5/6). Devices other than condenser mics may be damaged if connected to the phantom power supply. Note, however, that the switch may be left on without problem when connecting to balanced dynamic microphones. • To avoid damage to speakers, be sure to turn off amplifiers (or powered speakers) before turning this switch on or off. We also recommend that you turn all output controls (ST Master LEVEL Control, etc.) to minimum settings before operating the switch, to avoid risk of loud noises that could cause hearing loss or device damage. 2 RETURN Control Adjusts the level of the signal sent from the RETURN jacks (L (MONO) and R) to the Stereo bus. n If you supply a signal to the RETURN L (MONO) jack only, the mixer outputs the identical signal to both the L and R Stereo buses. 3 2TR IN/USB Control Adjusts the level of signals received via 2TR IN, as well as the level of signals received by the MW10 from the computer via the USB interface. 4 2TR IN/USB Switch (TO ST/TO C-R) Determines whether the stereo signal received via the 2TR IN connectors or USB interface is sent to the stereo bus or the C-R OUT connectors and PHONES jack (level meter). n • When the 2TR IN/USB switch is set to TO ST, the signal input via the 2TR IN/USB connector is added to the stereo bus. • When the 2TR IN/USB switch is set to TO C-R, the signal input via the 2TR IN/USB connector is directly sent to the C-R OUT/PHONES connector, and is not output via the stereo bus. 5 ST Master LEVEL Control Adjusts the signal level to the ST OUT jacks. 6 C-R/PHONES LEVEL Control Controls the level of the signal output to the PHONES jack and the C-R OUT L and R jacks. 7 Level Meter This LED display shows the level of the signal fed to the Stereo bus. The "0" point corresponds to the standard output level. The indicator lights up red when the output hits the clipping level. 8 POWER Indicator This indicator lights up when the mixer's power is ON. 16 MW10 Owner's Manual