Yamaha R-V703 Owner's Manual - Page 9

English R-V503 Turntable Monitor TV Video cassette recorder OUTPUT GND VIDEO IN VIDEO OUT AUDIO OUT VIDEO IN AUDIO IN 2 * 75Ω UNBAL. FM ANT VIDEO GND R MAIN L R SURROUND L CENTER SUB WOOFER 6CH DISCRETE INPUT MONITOR OUT VIDEO IN VCR OUT VIDEO SIGNAL GND AM ANT PHONO TAPE TAPE REC PB /MD OUT 34 VIDEO IN VCR OUT OUTPUT REAR CENTER (SURROUND) SUB WOOFER A B AUDIO SIGNAL 1 CD MAIN SEE INSTRUCTION MANUAL FOR CORRECT SETTING. SPEAKERS (Europe model) IMPEDANCE SELECTOR SET BEFORE POWER ON REAR 6ΩMIN. /SPEAKER CENTER SINGLE:6ΩMIN. /SPEAKER DUAL:3ΩMIN. /SPEAKER MAIN A OR B:4ΩMIN. /SPEAKER A B:8ΩMIN. /SPEAKER REAR 8ΩMIN. /SPEAKER CENTER SINGLE:8ΩMIN. /SPEAKER DUAL:4ΩMIN. /SPEAKER MAIN A OR B:8ΩMIN. /SPEAKER A B:16ΩMIN. /SPEAKER 1 * I00W MAX. TOTAL SWITCHED AC OUTLETS LINE OUT LINE IN VIDEO OUT AUDIO OUT OUTPUT To AC outlet Tape deck, MD recorder, etc. LD player, DVD player, etc. 1 *AC OUTLETS (SWITCHED) Use these to connect the power cords from your components to this unit. The power to the SWITCHED outlets is controlled by this unit's STANDBY/ON switch or the provided remote control transmitter's POWER /I key. These outlets will supply power to any component whenever this unit is turned on. The maximum power (total power consumption of components) that can be connected to the SWITCHED AC OUTLETS is 100 watts. CD player * *1 2 , : See below. 2 *GND terminal (For turntable use) Connecting the ground wire of the turntable to the GND terminal will normally minimize hum, but in some cases better results may be obtained with the ground wire disconnected. 9