Yamaha RX-10 Owner's Manual - Page 7

English How to Connect: Red: positive (+) Black: negative (-) 2 1 3 Banana Plug connections are also possible. Simply insert the Banana Plug connector into the corresponding terminal. Œ Unscrew the knob.  Insert the bare wire. [Remove approx. 5mm (1/4") insulation from the speaker wires.] Ž Tighten the knob and secure the wire. ABOUT THE ACCESSORY TERMINALS AC OUTLET(S) (SWITCHED) (Europe and General models)...........2 SWITCHED OUTLETS (U.K. model 1 SWITCHED OUTLET Use these to connect the power cords from your components to this unit. The power to the SWITCHED outlets is controlled by this unit's POWER switch or the provided remote control transmitter's POWER key. These outlets will supply power to any component whenever this unit is turned on. The maximum power (total power consumption of components) that can be connected to the SWITCHED AC OUTLET(S) is 100 watts. GND terminal (For turntable use) Connecting the ground wire of the turntable to this terminal will normally minimize hum, but in some cases better results may be obtained with the ground wire disconnected. GND 7